Kaba Mas AUDITCON 2 Series User manual

The following instructions cover Model 52 & T52 Super Master Operations. The
lock is shipped with a six-digit factory default Super Master User Combination
that can be set (i.e., changed) when the lock is in its default status from the
factory. Once the Super Master User Combination is set, it can only be used to
unlock the lock and reset it to the factory default combination (502550) in the
event the user combination(s) are lost.
WARNING: The setting of the Super Master User Combination is optional. If you
do not change the default Super Master Combination prior to changing any user
combinations, the Super Master reset capability will be permanently lost.
Important Note:The lock must be manually powered before each operation by
briskly turning the dial back and forth 44
44
433
33
3.
SET SUPER MASTER COMBINATION
Caution: Once the Super Master Combination is set, it can never be changed.
1. Press #and then 0.
G
8
2. Enter the factory default Super Master Combination of “120943”.
G
8
3. Enter the new six-digit Super Master Combination.
G
8.
4. Enter the new Super Master combination again for verification.
GR
5. Record the combination and store it in a secure place.
AUDITCON®2 SERIES
MODELS 52 & T52
SUPER MASTER OPERATIONS
Document Number 3055.025 Rev. B - 05/06

DETECT IF SUPER MASTER COMBINATION IS ACTIVE
1.Press #and then 9.
If the Super Master User combination has not been disabled (i.e., no
User combination has been changed) and has not been activated,
two red flashes
R R
display.
If the Super Master combination is active,
five red flashes
R R R R R
display.
If the Super Master combination has been permanently disabled,
a green flash
G
displays.
RESET LOCK USING SUPER MASTER COMBINATION
1. For a Dead Bolt, place the dial in the Home position.
2. Press #and then 0.
G
8.
3. Enter the Super Master combination.
The lock will respond as follows to indicate that the lock is ready to open:
Dead Bolt - 1 slow green flash
G
Slide Bolt - Continuous green flashes
G
... for approx. 5 seconds
4. For a Dead Bolt, dial right (clockwise) until the lock bolt is retracted. For a
Slide Bolt, rotate the container handle to unlock.
Note: The lock is now set to the factory default: Single Mode with an opening
combination of “502550”.
© 2005-2006 Kaba Mas Corporation. All rights reserved.
Kaba Mas Corporation
749 W. Short Street, Lexington, KY 40508 USA
Phone: [phone] FAX: [phone]
Technical Support: [phone]
www.kaba-mas.com