Kärcher KM 100 R LPG User manual

QUICKSTART
5.964-003.0 04/11
KM 100/100 R LPG
Warning
These are only brief instructions! Please read and comply with these instructions prior to using or servicing your
appliance.
The non-compliance of the operating and safety instructions may lead to damages of the appliance and to dangers
for the operator and other persons.
Start up
1A
C
F
B
D E
A Opening and securing cover
B Check oil level
C Check the hydraulic oil level on the storage
container.
D Check oil level in the equalisation container.
E Close cover.
F Open the gas drawing valve by turning it in
anti-clockwise direction.
2A B A Pull seat adjustment lever inwards.
B Slide seat, release lever and lock in place.
Check that the seat is properly locked in
position by attempting to move it backwards
and forwards.
Operation
1A
D
B
E
CStarting the machine
A Sit on the driver's seat.
B Do NOT press the accelerator pedal.
C Set programme switch to step 1 (driving).
D Press remote switch for 5 seconds, then
release it.
E Turn the ignition key to position "I".
If the machine starts, release the ignition key.

QUICKSTART
5.964-003.0 04/11
2ABCDrive the machine
A Press slowly the accelerator pedal "forward".
B Press slowly the accelerator pedal "reverse".
C Release the accelerator pedal, the machine
brakes automatically and stops.
3ASweeping with sweep roller
A Set programme switch to step 2.
Roller brush is lowered.
4ASweeping with side brushes
A Set programme switch to step 3.
Side brushes and roller brush are lowered.
5ASweeping with bulk waste flap raised
A Press the pedal for the bulk waste flap
forwards and keep pressed down.
To lower it, take foot off pedal.
6ASweeping damp or wet floors
A Open wet/dry flap.
7ACleaning the dust filter
ADuring operations, the dust filter should be
shaken and cleaned every 15-30 minutes
depending on the amount of collected dust.
8AEmptying waste container
A Raise the waste container slightly and
pull it out.
Empty waste container.
Push in the waste container and lock it.
Empty opposite waste container.
Operation

QUICKSTART
5.964-003.0 04/11
Finish operation
1A B Turn off the appliance
A Set programme switch to step 1 (driving).
The side brush and roller brush are raised.
B Turn ignition key to "0" and remove it.
2AClose the gas inlet
A Close gas drawing valve by turning it in
clock-wise direction.
3AEmptying waste container
A Raise the waste container slightly and
pull it out.
Empty waste container.
Push in the waste container and lock it.
Empty opposite waste container.

QUICKSTART
5.964-003.0 04/11
Maintenance and care
daily weekly Kärcher Customer Service
1AA Check engine oil level.
2AA Check gas pipes and connecting
screws.
Check gas filter in the screw to the
gas cylinder to see if it is dirty,
clean it if required (every time you
change the cylinder).
3AA Check air filter.
4AA Check dust filter and clean filter
box, if required.
5AA Clean the machine with a damp
cloth which has been soaked in
mild detergent.
몇Warning
Risk of damage! Do not wash down the
appliance with water and do not use
aggressive detergents.

QUICKSTART
5.964-003.0 04/11
Troubleshooting
1A B Appliance cannot be started
A Sit on the driver seat, the seat contact switch
gets activated
B Open the gas drawing valve by turning it in
anti-clockwise direction.
Replace gas bottle if required.
2AEngine is running erratically
A Clean or replace air filter
3AEngine is running but machine is not moving
A Check setting of freewheel lever
4A B Machine is not sweeping properly
A Check roller brush and side brushes for wear,
replace if necessary.
B Check function of bulk waste flap
5A
C
BDust gathers in the machine
A Empty waste container
B Check dust filter, clean or replace
C Close wet/dry flap
Roller brush does not turn.
A Remove belts or cords from roller brush