Kärcher KM 90 R Bp User manual

QUICKSTART
KM 90/60 R Bp
5.964-873.0 04/13
Warning
These are only brief instructions! Please read and comply with these instructions prior to using or servicing your
appliance.
The non-compliance of the operating and safety instructions may lead to damages of the appliance and to dangers
for the operator and other persons.
Start up
1A
D
B C A Grab the front of the appliance cover and fold
it back together with the seat.
B Unplug the charger from the mains.
C Place the mains cable into the storage
compartment.
D Close cover.
2ABCA Sit on the driver's seat.
B Pull seat adjustment lever inwards.
C Slide seat, release lever and lock in place.
Check that the seat is properly locked in
position by attempting to move it backwards
and forwards.
Operation
1ABCStarting the machine
A Sit on the driver's seat.
Do NOT press the accelerator pedal.
B Set programme switch to step 1 (driving).
C Set main switch to "1".
2A B Drive forward
A Set the travel direction switch to "forward".
B Press accelerator pedal down slowly.
Release the accelerator pedal, the machine
brakes automatically and stops.

QUICKSTART
KM 90/60 R Bp
5.964-873.0 04/13
3A B Reverse drive
A Set the travel direction switch to "backwards".
B Press accelerator pedal down slowly.
Release the accelerator pedal, the machine
brakes automatically and stops.
4ASweeping with sweep roller
A Set programme switch to step 2.
Roller brush is lowered.
The roller brush and the side brush
will rotate.
5ASweeping with side brushes
A Set programme switch to step 3.
Side brushes and roller brush are lowered.
6ASweeping with bulk waste flap raised
A Press the pedal for the bulk waste flap for-
wards and keep pressed down.
To lower it, take foot off pedal.
Note: An optimum cleaning result can
only be achieved if the bulk waste flap has
been lowered completely.
7ASweeping damp or wet floors
A Open wet/dry flap.
Note: You can thus preven the filter system
from getting blocked.
8AEmptying waste container
A Raise the waste container slightly
and pull it out.
Empty waste container.
Push in the waste container and lock it.
Empty opposite waste container.
Operation

QUICKSTART
KM 90/60 R Bp
5.964-873.0 04/13
Finish operation
1A B Turn off the appliance
A Set programme switch to step 1 (driving).
The side brush and roller brush are raised.
B Turn main key to "0" and remove it.
2AEmptying waste container
A Raise the waste container slightly and
pull it out.
Empty waste container.
Push in the waste container and lock it.
Empty opposite waste container.
3A B Charging process
A Open the device hood.
B Insert the plug of the charger into the socket.
Maintenance and care
daily weekly Kärcher Customer Service
1AA Check the sweeping roller and the
side brush for wear and wrapped
belts.
Remove belts or cords from roller
brush

QUICKSTART
KM 90/60 R Bp
5.964-873.0 04/13
2A
C
BA Loosen the screws.
B Fold the lid up and secure it by
means of the support.
C Check dust filter and clean filter
box, if required.
3AA Clean the machine with a damp
cloth which has been soaked in
mild detergent.
몇Warning
Risk of damage! Do not wash down the
appliance with water and do not use
aggressive detergents.
Troubleshooting
1A
D
B C Appliance cannot be started
A Sit on the driver seat, the seat contact
switch gets activated.
B Release emergency-stop button.
C Set main switch to "1".
D Check charging status of battery.
Indicator lamp glows green
Battery is charged (100...40%).
Indicator lamp glows yellow
Battery is discharged to 40 ... 20%.
Indicator lamp blinks red
Battery is almost discharged. The sweeping
mode will be shortly switched off automatically.
Indicator lamp glows red
Battery is discharged. The sweeping mode will
be terminated automatically (the sweeping
aggregates cannot be taken into operation until
the battery is charged).
Maintenance and care
daily weekly Kärcher Customer Service

QUICKSTART
KM 90/60 R Bp
5.964-873.0 04/13
2A B Machine is not sweeping properly
A Check roller brush and side brushes for wear,
replace if necessary.
B Check function of bulk waste flap
3A B Dust gathers in the machine
A Empty waste container
B Check dust filter, clean or replace
4A B Roller brush does not turn.
A Remove belts or cords from roller brush
Error code is displayed.
B Completely switch of the appliance and turn it
back on.
Troubleshooting