KI 700 Series User manual

AssemblyInstructions
KI700SeriesDeskReturn
August1997
Key Hole
Down
Hanger
Screw Worksurface
Detail A
Detail B
Desk End
Panel
Wire Management
Channel
Worksurface
3
1
2
5
4
Tools Required
ŸPhillips Screwdriver
Ÿ3/8” Socket/Wrench
Hardware Parts List
(9) #20162 - #8 x 1/2” Screws
(6) #20192 - #14 x 7/8” Screws
(2) #20201 - #14 x 7/8 Hanger Screws
(2) #20425 - Hex Glides
KI Pembroke
P.O. Box 580
1000 Olympic Drive
Pembroke, Ontario
K8A 6X7
TEL [phone]
FAX [phone]
1. To avoid scratching worksurface,
place top face down on a protective
surface.
2. Insert (2) hanger screws in predrilled
holes for end panels. Place end
panel over hanger screws and slide
into position (Detail A).
3. Position modesty panel against
end panel aligning holes with those
in end panel, fasten using (2-3)*
#8 x 1/2” screws.
4. Place wire management channel on
worksurface against end panel and
modesty panel, product label facing
inward, keeping predrilled holes
aligned. Bend tab in end panel over
wire management channel (Detail B).
Secure wire management channel in
place with (3) #8 x 1/2” screws.
5. Screw (2) hex glides in bottom of
end panel. See options on reverse.
6. Turn right side up for final
placement.
*(2) - #8 x 1/2” screws - partial
modesty panel
(3) - #8 x 1/2” screws - full modesty
panel
Components
1 - Desk Return
2 - Modesty Panel
3 - End Panel
4 - Wire Management Channel
5 - Level or Step Connector

PowerUp
Grommet
Worksurface
Shield
Worksurface
Hanger Screw
Pedestal
Mounting Pedestal to Worksurface
Mounting hardware included with
pedestal.
1. Determine on which side the pedestal
will be used.
Predrilled Hole
Thumb Screw
Detail A
Installing Grommets & PowerUp
Hardware Parts List
(4) #20162 - #8 x 1/2” Screws
1. Press worksurface grommets into
wireway holes in worksurface.
PowerUp Only
2. Route cord through the hole in the
worksurface. Snap the PowerUp
option into the hole in worksurface.
3. Install PowerUp shield to underside of
worksurface using (4) #8 x 1/2”
screws.
21174-3 Jan.2000
2. Install (4) hanger screws into 13/64”
dia. holes. CAUTION: Do not over
tighten.
3. Position back of pedestal to engage
with back hanger screws and slide
backward enough to allow front key
slots to engage. Continue to push
backward until full engagement is
reached.
4. Open top drawer, install thumb screw
through pedestal top and into
predrilled hole in the worksurface.
Thumb screw must be installed to
lock pedestal to the worksurface
(Detail A).
CAUTION
Assemble units as described herein only. To do otherwise may result in instability. All screws, nuts and bolts must
be tightened securely and must be checked periodically after assembly. Failure to assemble properly, or to secure
parts may result in assembly failure and injury.
13/64” dia. Hole