kingsley-bate AM-30 User manual

KINGSLEY – BATE
Fine Garden Furniture
ASSEMBLY INSTRUCTIONS FOR THE AM - 30/55/80
BACK SEAT
*NOTE
A TENON
B MORTISE HOLE
END FRAME END FRAME
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE: During assembly of the furniture please match all joints with the corresponding
letters or numbers stamped on the furniture.
STEP-II
Assemble the SEAT to the BACK with the 6mm brass knock down bolts. Screw in by
hand and tighten with a proper screw driver.
STEP-III

Place both END FRAMES flat with the mortise holes facing up. With the glue stick apply
a thin film of glue to the walls of the mortise holes.
If any excess glue squeezes out from the joints, wipe off with a slightly damp rag.
STEP-IV
Fit the assembled seat and back to one END FRAME. Match the numbered tenons with
the corresponding numbered mortise holes. Place the BOTTOM LEG STRETCHER into
the END FRAME mortise hole. If necessary, gently rock the BOTTOM LEG
STRETCHER until the joint fits snugly together.
STEP-V
Fit the second END FRAME into place. Using a rubber mallet or a hammer with the
sanding block between the hammer and the wood, drive the tenons and mortise holes
together until all joints fit snugly.
STEP-VI

After hammering the END FRAMES tight against the rails, insert the 8mm locking
dowels with a hammer in the pre drilled positions before lowering the sofa or settee to its
upright position. * IMPORTANT
Lowering the sofa or settee before doweling the item may cause damage to the
END FRAMES. Use the sanding block between the hammer and the dowels for
the last few blows to prevent marring the
wood.
STEP-VII
Insert the 6mm locking dowels into the BOTTOM LEG STRETCHER and END
FRAMES. Again, use the sanding block between the hammer and the dowels for the last
few blows to prevent marring the wood. If the dowels protrude above the wood, sand
level with the sanding block. Make sure to sand along the grain of the wood. *DO NOT
FORCE DOWELS*
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE
DEALER NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU
FOR CHOOSING OUR FURNITURE.
* KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]