kingsley-bate CB53 User manual

Kingsley-Bate
CB53 Cushion Storage Box
Assembly Instructions

KINGSLEY–BATE
Fine Garden Furniture
0ASSEMBLY INSTRUCTIONS FOR THE CB53/60
BACK/FRONT PANELS BOTTOM LID
END FRAMES HANDLES LID BOLTS
* NOTE:
A TENON
B MORTISE HOLE
1STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE: During assem bly of the furniture pleas e match all joints with the corresponding
letters or numbers stamped on the furniture.
STEP-II
Carefully place either the FRONT or BACK PANEL on a smooth, flat
surface with the mortise holes f acing up. Matching the stamped
numbers on the tenons with those next to the m ortise holes, gently insert
the END FRAMES and the BOTTOM into position as shown in the
photograph.
STEP-III
Fit the remaining PANEL over and onto the exposed tenons and using a
rubber mallet, drive all joints toge ther evenly. If you use a ham mer, put
the sanding block between the ham mer head and the wood to prevent
any damage or marring of the wood.
2STEP-IV
Drive locking dowels into place with a hammer. Use the sanding block
between the hammer head and the dowel to prevent m arring of the
wood. If dowel protrudes above the wood, sand it level with the sanding
block provided. Make sure to sa nd along grain of the wood. DO NOT
FORCE DOWELS.

STEP-V
From inside the box, insert the brass bolts
fitted with one washer each. Slide the
additional 4 washers over the exposed threads
on the outside of the box and using a proper
screw driver, secure the handl e into place. Use of any power screw driver could cause
damage to the hardware or wood.
STEP-VI
Mount the lid with the 6m m brass knock down bolts,
insert and slightly tighten all bolts by hand before
tightening with flat tipped screw driver. NOTE: THIS
WILL BE EASIER TO DO WITH 2 PEOPLE. YOU
DO NOT WANT TO LET THE WEIGHT OF THE LID
FALL BACKWARDS DURING ASSEMBLY.
STEP-VIII
The hydraulic stays are already fitted to the lid; fasten the wooden blocks
attached to the stay to inside of the box with the 6m m brass knock down
bolts.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACK THE NGSLEY-BATE DEALER
NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU FOR
CHOOSING OUR FURNITURE.
* KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
3IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY
7200 Gateway Court, Manassas, Virginia 20109
Phone. [phone], Fax. [phone]