kingsley-bate Nantucket NT30 User manual

Kingsley-Bate
NT30 Nantucket Lounge Chair
Assembly Instructions

KINGSLEY–BATE
Fine Garden Furniture
0ASSEMBLY INSTRUCTIONS FOR THE NT-30
BACK SEAT
*NOTE:
A TENON
B MORTISE HOLE
RIGHT END FRAME LEFT END FRAME
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE: During assembly of the furniture please match joints with the corresponding letters
or numbers.
STEP-II
Assemble the BACK and SEAT and secure
with the knock down bolts provided. Please
use a proper, hand held screw driver. Using
a power screw driver may damage the bolt.
STEP-III
Place the SEAT/BACK assembly and
BOTTOM STRETCHER into the RIGHT
END FRAME mortise holes.

STEP-IV
Fit the LEFT END FRAME mor tise holes over and onto the
BOTTOM STRETCHER and SEAT /BACK assembly tenons. If
necessary, use a rubber mallet to drive the joints snugly together.
STEP-V
Insert all dowels as shown in the assem bly photographs and drive t hem with a proper
hammer. DO NOT FORCE DOWELS FURTHER THAN THEY WILL GO. AN Y
EXCESS CAN EASILY BE SANDED AW AY. TO PREVEN T MARRING THE
WOOD, PLEASE USE THE WOOD BL OCK BETWEEN THE DOWEL AND THE
HAMMER HEAD FOR THE LAST FEW BLOWS.
IF YOU HAVE ANY QUESTION REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT A KINGSLEY-BATE
DEALER NEAR YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU FOR
CHOOSING OUR FURNITURE.
*KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY.
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]