kingsley-bate SR-30 User manual

KINGSLEY~BATE
Fine Garden Furniture
ASSEMBLY INSTRUCTIONS FOR THE SR-30/55/ 0
BACK SEAT INSERTS SEAT
*NOTE
A TENON
B MORTISE HOLE
END FRAME END FRAME
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE: During assembly of the furniture please match all joints with the corresponding
letters or numbers stamped on the furniture.
STEP-II
Carefully lay down the END FRAME with the stamped numbers or letters
on it and fit the SEAT & BACK tenons into the END FRAME mortise
holes as shown in the assembly photograph. If necessary, gently rock the
SEAT & BACK while pushing the tenons into place until the joints fit
snugly together (use a rubber mallet to drive the joints together if
necessary).
STEP-III
Fit the remaining END FRAME mortise holes over and onto all exposed
tenons. Using a rubber mallet or regular hammer with a wood block
between the hammer and the wood, drive the tenons and mortise holes until
all the joints fit snugly together.

STEP-IV
Upright product by having two people
LIFT the assembly and set it down;
DO NOT ROLL OVER PRODUCT
TO UPRIGHT POSITION AS THIS
COULD DAMAGE THE ITEM.
Hammer the dowels into their respective joints (dowel bags are marked according to where
they go). Make sure not to hit other parts of the bench. To avoid dimpling the wood, we
suggest you place a block of wood between the dowel head and the hammer head for the last
few blows. If dowels are not completely flush, use a saw to cut the ends and then sandpaper
to smooth the top. * After hammering, if dowels still protrude DO NOT FORCE!
STEP-V
Place INSERTS into SEAT as shown in photograph.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE DEALER
NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU FOR
CHOOSING OUR FURNITURE.
* KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]