kingsley-bate Hyannis HY-118 User manual

KINGSLEY BATE
Fine Garden Furniture
ASSEMBLY INSTRUCTIONS FOR THE HY-118
LEG ASSEMBLY TABLE TOP LEG ASSEMBLY
* NOTE
A TENON
B MORTISE HOLE
HARDWARE
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring
the wood.
NOTE: During assembly of the furniture please match all joints with the
corresponding letters or numbers stamped on the wood.
STEP-II
Fit mortise holes of the LEG ASSEMBLY onto the respective tenons
of the TABLE TOP. If necessary, use rubber mallet to drive the
tenons into place until all joints fit snugly together.
STEP-III
Secure LEG ASSEMBLY as shown in photographs using 1 Knock-
Down Bolt and 2 Dowels. Use a wood block between the hammer
head and the dowel head for the last few blows to avoid marring the
wood.

**NOTE**
TABLE MUST BE UPRIGHTED BY TWO PEOPLE, ROLLING THE
TABLE OVER MAY CAUSE STRUCTURAL DAMAGE TO ITEM.
LEGS ARE NOT DESIGNED TO HANDLE THE PRESSURE OF
ROLLING OVER THE TABLE. MUST LIFT OFF THE GROUND,
ROTATE OVER AND SET DOWN RIGHT SIDE UP.
STEP-IV
To use EXTENSIONS, release the BUCKLES under the TABLE TOP, pull the
edge of the TABLE TOP out like a drawer to reveal EXTENSIONS; roll them
over into position and lock the EXTENSIONS into place.
BUCKLES
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY BATE FURNITURE, PLEASE CONTACT KINGSLEY BATE
CUSTOMER SERVICE AT 703-361-7000. WE THANK YOU FOR CHOOSING OUR
FURNITURE.
* KINGSLEY BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]