kingsley-bate MC-10 User manual

KINGSLEY–BATE
Fine Garden Furniture
ASSEMBLY INSTRUCTIONS FOR THE MC-10
LEG ASSEMBLY SEAT LEG ASSEMBLY
*NOTE
A TENON
B MORTISE HOLE
STEP-I
Unpac , inspect and lay the parts on a clean, flat,
soft surface to avoid marring the wood.
NOTE: During assembly of the furniture please match all joints with the corresponding
letters or numbers stamped on the furniture.
STEP-II
Carefully lay the SEAT on a flat, smooth surface and fit the LEG
ASSEMBLIES mortise holes onto the SEAT tenons as shown in the
assembly photograph. Joints are meant to fit snugly together, if
necessary use a rubber mallet or a hammer with the sanding bloc
provided between the hammer head and the LEG ASSEMBLIES to
drive the LEG ASSEMBLIES into position.
STEP-III
Hammer the dowels into all the pre-drilled holes of the assembly as
shown in the photograph. Use the sanding bloc between the hammer
and the dowels for the last few blows to prevent marring of the wood.
DO NOT FORCE DOWELS ANY PROTRUDING DOWEL CAN
EASILY BE SANDED DOWN.

STEP-IV
***OPTIONAL*** Rubber glides are provided for your items but are not
necessary. Secure them to the bottom of the legs using a proper, hand held
screw driver. Using a power driver might strip the head of the screw or damage
the glide. Starter holes are visible as shown in the first photograph.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE DEALER
NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU FOR
CHOOSING OUR FURNITURE.
* KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]