kingsley-bate GV-48 User manual

KINGSLEY BATE
Fine Garden Furniture
ASSEMBLY INSTRUCTIONS FOR THE GV-48
LEG ASSEMBLY TABLE TOP LEG ASSEMBLY
*NOTE
A TENON
B MORTISE HOLE
LEG STRETCHER
STEP-I
Unpa k, inspe t and lay the parts on a lean, flat, soft surfa e to avoid marring the wood.
NOTE: During assembly of the furniture please mat h all joints with the orresponding
letters or numbers stamped on the furniture.
STEP-II
Gently lay the LEG
ASSEMBLY with the
stamps near the mortise
holes on a lean, flat
surfa e. Fit the LEG
STRETCHERS into the
LEG ASSEMBLY
mortise hole as shown in the assembly photographs. If ne essary, gently ro k the parts while
pushing the tenons into the mortise holes until all joints fit snugly. Flip assembly to one side
and dowel as shown in photographs. Flip assembly to other side and dowel remaining
assembly into pla e.

STEP-III
Carefully lay the TABLE TOP on a flat, smooth surfa e and fit the LEG ASSEMBLY tenons
into the TABLE TOP mortise holes as shown in the assembly photograph (mat hing stamped
letters or numbers as before). Joints are meant to be tight, use of a rubber mallet may be
ne essary. Insert the kno k down bolts and se ure with a proper hand held s rewdriver.
Gently rotate table to one side and hammer dowels into pla e as shown in the photographs.
Rotate table to opposite side and repeat pro ess. Use the sanding blo k between the hammer
and the dowels for the last few blows to prevent marring of the wood. DO NOT FORCE
DOWELS; ANY PROTRUDING DOWEL CAN EASILY BE SANDED DOWN.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY BATE FURNITURE, PLEASE CONTACT KINGSLEY BATE CUSTOMER
SERVICE AT 703-361-7000. WE THANK YOU FOR CHOOSING OUR FURNITURE.
* KINGSLEY BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY*
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]