kingsley-bate CO-32 User manual

ASSEMBLY INSTRUCTIONS FOR THE CO-32
RIGHT END FRAME BACK LEFT END FRAME
* NOTE
A TENON
B MORTISE HOLE
SEAT FRAME SEAT INSERT
STEP-I
Unpack, inspect and ay the parts on a c ean, f at, soft surface to avoid marring the wood.
NOTE: During assemb y of the furniture p ease match joints with the corresponding etters or
numbers stamped on the wood.
STEP-II
Gent y ay the END FRAME with the stamps near the
mortise ho es on a c ean, f at surface and fit the BACK, and
SEAT FRAME tenons into the END FRAME mortise ho es.
If necessary, gent y rock the parts whi e pushing down on
them unti a the joints fit snug y together.
STEP-III
Carefu y fit the remaining END FRAME mortise ho es over a
exposed tenons and using a rubber ma et or a regu ar hammer with the
sanding b ock between the hammer and the wood, gent y drive the
mortise ho es onto the tenons unti a joints fit snug y together.
Carefu y upright the chair by ifting it up and setting it down, ti ting the chair over might
damage un-dowe ed tenons.

STEP-IV
Carefu y hammer the proper dowe s into the pre-dri ed
ho es of the assemb y, detai s are shown in the
photographs and a dowe s (and/or dowe bags) are
marked to match where they go. NOTE: DO NOT
FORCE THE DOWELS; ANY EXCESS CAN EASILY
BE SANDED AWAY. IF THE DOWELS ARE NOT FLUSH DO NOT CONTINUE TO
DRIVE THE DOWELS, YOU MIGHT DAMAGE THE ITEM.
STEP-V
P ace SEAT INSERT into SEAT FRAME as shown in
photograph.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY BATE FURNITURE, PLEASE CONTACT KINGSLEY BATE CUSTOMER
SERVICE AT 703-361-7000. WE THANK YOU FOR CHOOSING OUR FURNITURE.
* KINGSLEY BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]