kingsley-bate Classic CL70 User manual

Kingsley-Bate
CL70 Classic Chaise Lounge
Assembly Instructions

KINGSLEY – BATE
Fine Garden Furniture
0ASSEMBLY INSTRUCTIONS FOR THE CL - 70
*NOTE
A TENON
2B MORTISE HOLE
BACK LEG FRONT LEG
I
inspect and lay the parts on a clean, flat, soft surface to
s
HAISE FRAME
the FRONT LEGS m aking sure to
e
STEP-
Unpack,
avoid marring the wood. Lay the C HAISE FRAME on its back side
with mortise holes facing up as shown in the assembly photograph.
NOTE: During assem bly of the furniture please m atch all joint
with the corresponding letters or numbers stamped on the furniture.
3C
STEP-II
Assemble
match the num bered tenons to the corresponding
mortise holes. With a rubber m allet gently knock
the front legs into place as shown in the pictures.
If you use a hammer be sure to place th
sanding block between the hammer and the leg. This will prevent marring the wood.
STEP-III
After hammering the legs tight agains t the stretcher bar, insert the
locking dowels and drive them in gently. Again, if you use a
hammer, please place the sanding block between the dowel and the
hammer to prevent any marring of the w ood. Do not force the
dowels. If dow els are not completely flush just sand aw ay any
excess with the sanding block.
STEP-IV
rting the brass bo lts through the wheels, slide Before inse
one washer onto each bolt. Insert the bolts through the
wheels and slide on the second washers and then connect
the wheel assemblies to the back legs (see pictures).

STEP-V
the axle to th e wheel and back leg
ber mallet, gently knock the front
Connect
assemblies. Screw in by hand and finish with a ¾”
or standard adjustable wrench. Do not tighten too
hard, or the wheels will not turn.
STEP-VI
With a rub
and back leg assem blies into their
corresponding places. Be sure to match the
numbered tenons w ith the corresponding
mortise holes.
II
STEP-V
screws into the back leg braces to secure
hammer. You ould place the a
STEP-VIII
gs tight against the side rails, insert
Insert brass
the legs to the chaise fra me. Do not ham mer in the
screws, but drive them in with a proper screw driver.
With the legs tight against the side rails, insert the
locking dowels and drive them in gently with a
nding block between the ham mer and the dowel to
prevent marring of the wood. If any dowels protrude, please do not force them in. Any
excess can easily be sanded away.
sh s
With front le
the locking dowels and drive them in gently with a
hammer. Again being careful not to mar the
wood. If any dow els protrude, please do not
force them in. Any excess can easily be sanded
away. Make sure to sand along the grain of the
wood to prevent scratch marks.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
ING
* KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
1
7200 Gateway Court, Manassas, Virginia 20109
K SLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE
DEALER NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU
FOR CHOOSING OUR FURNITURE.
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY
Phone: [phone], Fax: [phone]