kingsley-bate CL-18A User manual

KINGSLEY–BATE
Fine Garden Furniture
ASSEMBLY INSTRUCTIONS FOR THE CL-18A
SEAT BACK
* NOTE:
A TENON
B MORTISE HOLE
RIGHT END FRAME LEFT END FRAME
STEP-I
Unpac , inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE: During assembly of the furniture please match all joints with the corresponding
letters or numbers stamped on the furniture.
STEP-II
Fit the BACK, BOTTOM LEG STRETCHER and FRONT SEAT RAIL
tenons into the end frame mortise holes. If necessary, gently roc the
parts while pushing tenons into place until joints fit snugly together.
STEP-III
Fit the remaining END FRAME mortise holes onto all exposed tenons as
shown in photographs and carefully upright chair by lifting it and setting
it down while holding the END FRAMES in place securely.

STEP-IV
Place SEAT into the chair frame as shown in the pictures below and secure noc -down bolts
using a proper screw driver; be careful not to over tighten bolts.
STEP-V
Carefully hammer dowels into respective joints,
ma ing sure not to hit other parts of the chair. To
avoid dimpling the wood we suggest you place a
bloc of wood between dowel head and hammer
head on the last few blows. If dowels are not
completely flush, use a saw to cut the ends and then sandpaper to smooth the tops. *After
hammering, if dowels still protrude do not continue hammering! Insert brass screws into
respective pre-drilled SEAT holes (see picture). Do not hammer in the screws, but drive them
in with a proper screw driver.
Note: For easier doweling you may want to place the BACK of the chair on a protected table
top as shown in the assembly picture.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE DEALER
NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU FOR
CHOOSING OUR FURNITURE.
* KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY.
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]