kingsley-bate SH-52 User manual

KINGSLEY~BATE
Fine Garden Furniture
ASSEMBLY INSTRUCTIONS FOR THE SH-52/6
TABLE TOP GLASS TOP BASE
CROSS BRACKET
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wicker.
STEP-II
Line up the CROSS BRACKET to the
BASE assembly holes using the stickers
as guides.
Slide the flat washers followed by the
split washers onto the KD (knock-down)
BOLTS and secure all KD BOLTS as
shown in photographs with the allen key
provided. NOTE: it is easiest if you attach and lightly tighten all bolts first to make sure they
catch properly; then evenly tighten them the rest of the way down until completely secure.

STEP-III
Place the TABLE TOP upside down on a clean, flat surface and flip the BASE over and onto
it as shown in the above photographs. Line up the CROSS BRACKET to the TABLE TOP
assembly holes using the stickers on both parts.
STEP-IV
Slide the flat washers followed by the split washers onto the KD
(knock-down) BOLTS and secure all KD BOLTS as shown in
photographs with the allen key provided. NOTE: it is easiest if you
attach and lightly tighten all bolts first to make sure they catch
properly; then evenly tighten them the rest of the way down until
completely secure.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE DEALER
NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU FOR
CHOOSING OUR FURNITURE.
* KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY
7200 Gateway Court, Manassas, Virginia 20 09
Phone: [phone], Fax: [phone]