kingsley-bate GV-55 User manual

KINGSLEY BATE
Fine Garden Furniture
ASSEMBLY INSTRUCTIONS FOR THE GV-55
RIGHT END FRAME INSERTS LEFT END FRAME
BACKS SLATS SEAT FRAME
* NOTE
A TENON
B MORTISE HOLE
MIDDLE LEG HARDWARE
STEP-I
Unpac , inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE: During assembly of the furniture please match joints with the corresponding letters or
numbers stamped on the wood.

STEP-II
Fit the MIDDLE LEG onto the SEAT FRAME, secure the MIDDLE LEG and SEAT FRAME
with the bolt and Allen ey provided and carefully set off to the side. Gently lay the END
FRAME with the stamps near the mortise holes on a clean, flat surface and fit the BACK
SLATS into the END FRAME mortise holes as shown in the above photographs. Carefully
line up and fit the BACK SLATS into the MIDDLE LEG holes while adding the SEAT
assembly to the END FRAME (we recommend a second person help with this step). If
necessary, gently roc the parts while pushing down on them until all the joints fit snugly
together.
STEP-III
Carefully fit the rest of the BACK SLATS into the
MIDDLE LEG mortise holes and fit the remaining
END FRAME mortise holes over all exposed
tenons. Using a rubber mallet or a regular hammer
with the sanding bloc between the hammer and the
wood, gently drive all the mortise holes onto the
tenons until all joints fit snugly together.

STEP-IV
Carefully hammer the proper dowels into the pre-drilled holes of the assembly small dowels
“S “ for the bac , “M” for the front seat and long dowels “L” for the bac seat and the slats
near the seat, details are shown in the photographs and all dowels (and/or dowel bags) are
mar ed to match where they go. You will need 2 people to upright the Settee. DO NOT TIP
OVER. To upright lift off the ground, rotate to horizontal position and set item down. Drop
SEAT INSERTS into place.
NOTE: DO NOT FORCE THE DOWELS; ANY EXCESS CAN EASILY BE SANDED
AWAY. IF THE DOWELS ARE NOT FLUSH DO NOT CONTINUE TO DRIVE THE
DOWELS, YOU MIGHT DAMAGE THE ITEM.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY BATE FURNITURE, PLEASE CONTACT KINGSLEY BATE CUSTOMER
SERVICE AT 703-361-7000. WE THANK YOU FOR CHOOSING OUR FURNITURE.
* KINGSLEY BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY*
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]