kingsley-bate CO-62R User manual

ASSEMBLY INSTRUCTIONS FOR THE CO-62R/63L
BACK SEAT INSERTS SEAT
END FRAME ARMREST END FRAME DOWELS
*NOTE
A TENON
B MORTISE HOLE
STEP-I
Unpack, inspec and lay he par s on a clean, fla , sof surface o avoid
marring he wood.
NOTE: During assembly of he furni ure please ma ch all join s wi h he corresponding
le ers or numbers s amped on he furni ure.
STEP-II
Carefully lay down he ARMREST END FRAME wi h he s amped
numbers or le ers on i and fi he SEAT & BACK enons in o he END
FRAME mor ise holes as shown in he assembly pho ograph. If necessary,
gen ly rock he SEAT & BACK while pushing he enons in o place un il
he join s fi snugly oge her (use a rubber malle o drive he join s oge her
if necessary).
STEP-III

Fi he remaining END FRAME mor ise holes over and on o all exposed enons. Using a
rubber malle or regular hammer wi h a wood block be ween he hammer and he wood, drive
he enons and mor ise holes un il all he join s fi snugly oge her.
STEP-IV
Hammer he dowels in o heir respec ive
join s (dowel bags are marked according
o where hey go). Make sure no o hi
o her par s of he bench. To avoid
dimpling he wood, we sugges you
place a block of wood be ween he
dowel head and he hammer head for he las few blows. If dowels are no comple ely flush,
use a saw o cu he ends and hen sandpaper o smoo h he op. DO NOT FORCE!
STEP-V
Place SEAT INSERTS in o
SEAT as shown in
pho ographs.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY BATE FURNITURE, PLEASE CONTACT KINGSLEY BATE CUSTOMER
SERVICE AT 703-361-7000. WE THANK YOU FOR CHOOSING OUR FURNITURE.
* KINGSLEY BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY.
7200 Ga eway Cour , Manassas, Virginia 20109
Phone: [phone], Fax: [phone]