kingsley-bate MC-80 User manual

KINGSLEY–BATE
Fine Garden Furniture
ASSEMBLY INSTRUCTIONS FOR THE MC-80
BACKS
SEAT FRAME MIDDLE LEGS
* NOTE
A TENON
B MORTISE HOLE
INSERTS
STEP-I
Unpac , inspect and lay the parts on a
clean, flat, soft surface to avoid marring
the wood.
NOTE: During assembly of the furniture
please match joints with the
corresponding letters or numbers
stamped on the wood.
RIGHT END FRAME LEFT END FRAME

STEP-II
Gently lay the END FRAME with the stamps near the
mortise holes on a clean, flat surface and fit the first BACK
tenons into the END FRAME mortise holes. Fit the first
MIDDLE LEG into the first BACK. If necessary, gently
roc the parts while pushing down on them until all the
joints fit snugly together.
STEP-III
Carefully fit the SEAT into the END FRAME and secure the first MIDDLE LEG to the
SEAT with the KD BOLT provided; gently tighten with Allen Key. Fit the second BACK
tenons into the first MIDDLE LEG mortise holes and gently push into place. Fit the second
MIDDLE LEG to the second BACK, secure the second MIDDLE LEG to the SEAT and
tighten with Allen Key. Please do not forget to tighten the MIDDLE LEG to the SEAT with
Allen Key first before you fit the second and the third BACK (this will balance the assembly
so it won’t fall over).
STEP-IV
Fit the third BACK into the second MIDDLE LEG
mortise holes and gently push into place. Fit the
remaining END FRAME mortise holes over all exposed
tenons and using a rubber mallet or a regular hammer
with the sanding bloc between the hammer and the
wood, gently drive all the mortise holes onto the tenons
until all joints fit snugly together.
STEP-V

Carefully hammer the proper dowels into the pre-drilled holes of the assembly, details are
shown in photographs and all dowels (and/or dowel bags) are mar ed to match where they
go. NOTE: DO NOT FORCE THE DOWELS; ANY EXCESS CAN EASILY BE SANDED
AWAY. IF THE DOWELS ARE NOT FLUSH DO NOT CONTINUE TO DRIVE THE
DOWELS, YOU MIGHT DAMAGE THE ITEM. YOU WILL NEED TWO PEOPLE TO
UPRIGHT SOFA. LIFT AND SET DOWN, DO NOT TILT SOFA INTO UPRIGHT
POSITION AS THIS COULD DAMAGE YOUR ITEM.
STEP-VI
Place INSERT into SEAT FRAME as shown in photograph.
STEP-VII
***OPTIONAL***
Rubber glides are
provided for your items
but are not necessary.
Secure them to the
bottom of the legs using a proper, hand held screw driver. Using a power driver
might strip the head of the screw or damage the glide. Starter holes are visible
as shown in the first photograph.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE DEALER
NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU FOR
CHOOSING OUR FURNITURE.
* KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]