Knoll Pixel KYPW8436C User manual

PIXEL™ Installation Instructions
Y-Leg Flip-top Tables
Casters only
Unboxing
You should have received your top plus two boxes per table.
Box 1 includes:
Leg assemblies, hardware in a red plastic bag, and installa-
tion instructions.
Box 2 includes:
Horizontal rails
Hardware
8 Flat head 1/4 - 20 screws
8 Socket cap head 1/4 - 20 screws
4 5/16” Shoulder screws
2 Vertical wire management clips
(clear plastic)
4 Horizontal wire management clips
with wood screws
Related tables:
KYPW7236C
KYPW8436C
Please pay close attention to torque requirements.
Step 1.
Attach the leg assemblies (A) on each end of the
two horizontal rails (B) with flat head 1/4 - 20
screws (C), 4 per rail. Use 5/32” allen wrench,
torque: 50 in/lbs
Parts list
1 Table top
2 Leg assemblies
2 Horizontal rails
2 Top brackets
Tools needed
Allen wrenches
Phillips screwdriver
Torque wrench
Fig. 1
C
C
C
C
B
B
A
A
4AU6007 - Oct 2015
Page 1 of 3

PIXEL™ Installation Instructions
Y-Leg Flip-top Tables
Step 2.
Lay the inverted table top on the floor.
Attach table top brackets (D) to table top
with socket cap head 1/4 - 20 screws (E)
4 per bracket. Use 3/16” allen wrench,
torque: 130 in/lbs
Step 3.
Position the leg and horizontal rail
subassembly (F) on the underside of
the top. Align and attach the leg and
horizontal rail subassembly with the
table top brackets (G), using 5/16”
shoulder screws (H), 2 per casting. Use
5/32” allen wrench, torque: 50 in/lbs
Fig. 2
E
E
D
D
Fig. 3
G
G
F
H
H
4AU6007 - Oct 2015
Page 2 of 3

PIXEL™ Installation Instructions
Y-Leg Flip-top Tables
Step 4.
Turn the table assembly over into the upright
position.
Step 5.
Attach the gas cylinder to the leg and horizontal
rail subassembly (I) and the table top (J).
All tables come with 2 vertical wire
management clips, 4 horizontal wire
management clips and wood screws for
use with optional electronic modules. See
separate electrical installation instructions
for details.
If the table is being used as a stand-alone
piece and the ganging mechanism will not
be used, you can remove the mechanisms
by unscrewing them.
Fig. 4
J
I
4AU6007 - Oct 2015
Page 3 of 3