Kohler Englefield Valencia Elite User manual

SHOWER
VALENCIA ELITE
Corner Sliding 12x9
englefield.co.nz
1371374-A02-B October 2023

Before installing the shower please read these instructions carefully to familiarise
yourself with the required tools, materials and installation sequences. Please leave these
instructions for the consumer after installation. Refer to the separate care and maintenance
guide for important care and cleaning information.
Ensure that the shower tray and wall, if applicable, are completely finished prior to
installing your shower door and return. Follow all warnings, cautions and instructions
contained in this guide.
1. ENGLEFIELD strongly recommends that a minimum of TWO persons install this
enclosure due to the weight of the door panels.
2. Toughened safety glass cannot be cut. Risk of injury or product damage.
3. Wear protective footwear when lifting panels.
4. Wear safety glasses when drilling.
1. The wall retainers must be installed onto a waterproof, vertical and flat wall surface.
Failure to do so will result in an unsatisfactory seal, which may cause property damage.
The wall inclination (out of squareness) is recommended to be out by no more than
+/- 4mm/m.
2. Please install this door onto an ENGLEFIELD Quick - Fit Low Profile
shower tray only, unless installing directly onto tiled walls and floor.
®
3. Care must be taken when drilling into walls and floors to avoid any hidden pipes or
wires.
4. It is the responsibility of the INSTALLER to ensure that the installation complies with
council and or local authority bylaws.
INSTALLATION INSTRUCTIONSVALENCIA ELITE
BEFORE YOU BEGIN
SAFETY
!
!ATTENTION
Instructions, drawings, and diagrams contained in this manual present information available at the time of printing.
changes without further notice.
Corner Sliding Shower
Page 1 englefield.co.nz
1371374-A02-B October 2023

INSTALLATION INSTRUCTIONS
TOOLS AND MATERIALS REQUIRED
PARTS IDENTIFICATION
3.0 mm
2.0 mm - supplied
#1
Square
Drive
2 x Wall
Channels
1 x Door
1 x Door Frame
1 x Seal Pack
2 x Corner
Covers
2 x Wall
Finishing Strips
VALENCIA ELITE Corner Sliding Shower


4 x Roller
Covers
8 x Fixing
Screws
8 x Assembly
Screws
2 x Cover Caps
2 x Cover Caps
B
A
1 x Handle Assembly
1 x Hex Key


1 x Fittings Kit
1 x Handle Kit
Page 2 englefield.co.nz
1371374-A02-B October 2023

INSTALLATION INSTRUCTIONS
1 x Drip Strip Extrusion
1 x Side Panel
4 x Assembly Screws
2 x Top Caps
1 x Top Cap
1 x Screw Spacer
4 x Cover Caps
C
VALENCIA ELITE Corner Sliding Shower
Page 3 englefield.co.nz
1371374-A02-B October 2023

CONSTRUCTION REQUIREMENTS
Due to the weight of the glass panels Englefield strongly recommends
constructing double studs (as below) to fix the wall retainers to.
!ATTENTION
INSTALLATION INSTRUCTIONS
A
Double
studs
Double
studs
B
Size Dim ‘A’
1200 x 900 LH 1200
900
Dim ‘B’
900
1200
1200 x 900 RH
VALENCIA ELITE Corner Sliding Shower
2005mm
Minimum
Height
Page 4 englefield.co.nz
1371374-A02-B October 2023

INSTALLATION - Options
Page 5
INSTALLATION INSTRUCTIONS
Tray: For tray installation refer to the instructions supplied with the tray.
Wall: For wall installation refer to the instructions supplied with the wall.
- Proceed to Door and Return Installation.
- The door and return can be installed directly onto the wall and floor tiles.
- Proceed to Door and Return Installation.
OPTION 1 - Acrylic Wall & Tray
OPTION 2 - Tiled Wall & Acrylic Tray
OPTION 3 - Tiled Wall & Floor
Tray: For tray installation please refer to the instructions supplied with the tray.
Wall:
- The vertical wall retainers MUST be installed onto the waterproof membrane PRIOR TO
WALL TILING. If possible the complete door system should be installed onto the
waterproof membrane prior to wall tiling.
CAUTION: Failure to install the wall retainers first may
mean the door system may not fit on the shower tray
due to the tile thickness.
- If not installing the complete door system prior to tiling,
install the wall retainers and tiles. The retainer cover
extrusion can be inserted after tiling - there is no need
to leave a tiling gap. Refer to image.
- Proceed to Door and return installation.
Tile up to
retainer
VALENCIA ELITE Corner Sliding Shower
Page 5 englefield.co.nz
1371374-A02-B October 2023

± 0 mm ± 0 mm
Caution: Ensure tray or tiled floor is
For tray base option:
- Mark 10mm in from top edge of tray.
For tiled base option:
- Mark from finished wall to outer edge
of retainer.
Tip: Cover the waste to prevent the loss of
small parts. If installing onto a tray protect
the tray surface during installation.
Page 5
10 mm
10 mm
1200 x 900 LH
1200 x 900 RH
1175 875
875 1175
ASize B
INSTALLATION INSTRUCTIONS
INSTALLATION
1
B
A
(a) Mark the locations of the wall retainers.
level & walls are vertical & square.
VALENCIA ELITE Corner Sliding Shower
Page 6 englefield.co.nz
1371374-A02-B October 2023

INSTALLATION INSTRUCTIONS
(a)
Position the wall channels on the wall. The short leg should face inside the shower
enclosure. Using a level, ensure that the channels are upright.
Mark the position of the fixing holes down the centre of the channels, then remove
the wall channels. Note! The wall channel is not fitted at this stage.
Drill with a 3mm bit. For other types of wall structure, alternative fixings may be
required (not supplied).
(b)
(c)
Apply silicone sealant along the length of the wall and at the bottom where the wall
channel will be placed, including the top of the tray.
(d)
Position the wall channels on the wall and install the fixing screws .
(e)
Fully tighten the fixing screws, making sure that the wall channels are upright.
(f)
2
10 mm
± 0 mm
3 mm
x4
x4
A
A
VALENCIA ELITE Corner Sliding Shower
Page 7 englefield.co.nz
1371374-A02-B October 2023

INSTALLATION INSTRUCTIONS
replace the top roller assemblies
To switch the door orientation,
with the bottom roller assemblies.
Note! The roller assemblies with
the push button will be at the
bottom.
Door
(a) The sliding door can be either a LH or RH opening. To change the opening simply
rotate the frame through 180º before continuing with the installation.
Note! If you rotate the frame, then you will need to rotate the door so that the
handle holes are in the correct position. You may also need to swap the roller
assemblies around (the rollers with screw adjustment need to be at the top).
3
Logo badge on
outside of shower
Long leg
to outside
RH LH
VALENCIA ELITE Corner Sliding Shower
Page 8 englefield.co.nz
1371374-A02-B October 2023

Sliding Door
Side Panel
INSTALLATION INSTRUCTIONS
4
Sliding Door
Side Panel
(a)
(a)
The door orientation denotes the direction of the side panel. Once the door is in its
correct orientation, fit the drip strip extrusion to the bottom edge of the side panel.
Gently tap extrusion into place with a rubber mallet.
(b)
(b)
(c)
(c)
(d)
(d)
(d)
Fit the corner posts together, ensuring that the door and side panel engage correctly.
Install the side panel into the other wall channel.
Install the door frame into the wall channel.
VALENCIA ELITE Corner Sliding Shower
Page 9 englefield.co.nz
1371374-A02-B October 2023

INSTALLATION INSTRUCTIONS
5
Ø 3 mm
x4
± 0 mm
(a)
(a)
From the inside of the enclosure, drill four holes in the door frame through the
centre marked points on the wall channel with a 3 mm HSS drill (not supplied).
If frame adjustment is required, keep corner post assembly fitted tightly together
and carefully slide the frame (door and/or side panel) out from the wall channels.
(b)
Install and tighten the wall channel assembly screws .
(c)
Repeat the process for the other wall channel.
(d)
Fit the corner covers to the wall channels. They should ‘snap’ into place.
B
B
Sliding Door
Side Panel
Sliding Door
Side Panel
(e)
VALENCIA ELITE Corner Sliding Shower
Page 10 englefield.co.nz
1371374-A02-B October 2023

(a)
(b)
Use the Screw Spacer to install screws into the four corner post holes, then tighten.
The Screw Spacer is to help prevent losing screws within the corner post assembly.
Fit the screw cover caps over the screwheads.
INSTALLATION INSTRUCTIONS
6
C
C
VALENCIA ELITE Corner Sliding Shower
Page 11 englefield.co.nz
1371374-A02-B October 2023

INSTALLATION INSTRUCTIONS
7
(a) Hang the door onto the top rail.
Note! Make sure that the top rollers have adjusting screws facing downwards.
(b)
Loosen the top rollers with the adjusting screw until the bottom rollers easily clip into
the bottom rail.
(c)
Finally, tighten the roller adjustment to give an even, smooth action when the door is
opened and closed.
VALENCIA ELITE Corner Sliding Shower
Page 12 englefield.co.nz
1371374-A02-B October 2023

INSTALLATION INSTRUCTIONS
8
(a) Install the door handle, ensuring the grub screws are on the underside.
(b)
(c) Lock the top roller assemblies in position by turning the lock through 90º.
(d) Fit the roller covers.
Fit the seals to the door and the fixed panel.
Rotate 90°
Unlocked Locked
VALENCIA ELITE Corner Sliding Shower
Page 13 englefield.co.nz
1371374-A02-B October 2023

INSTALLATION INSTRUCTIONS
9
(a)
Apply sealant along the outside surfaces of the enclosure.
Install the wall finishing strips, if desired.
(b)
Allow the silicone sealant to cure for 24 hours before use.
(c)
Fit the caps to the top of the extrusions. Add silicone or modify caps to fit if required.
(d)
VALENCIA ELITE Corner Sliding Shower
Full length
200mm up
Full length
200mm up
Full length
Full length
wall
retainer
channel
silicone/adhesive
wall
liner
finishing
strip
- Installation complete -
Both ends of
side panel strip
Page 14 englefield.co.nz
1371374-A02-B October 2023

INSTALLATION INSTRUCTIONS
CLEANING AND MAINTENANCE INSTRUCTIONS
Please refer to the homeowners guide and our website for cleaning instructions.
SPARE PARTS
Seal (fixed panel)
1382132
Seal (door)
1382133
Retainer Cover
1278348-**
Wall Finishing Strip
1315530-**
Side Panel Bottom Strip
1348296-**
Top Roller
1260199-**
Bottom Roller
1260200-**
Side Panel Fittings Kit
1348297-**
Magnetic Seal
1260196
Wall Channel
1278347-**
Door (glass only)
1348294
Door Frame
1348293-**
Fittings Kit
1348295-**
Handle Assembly
1365840-**
Glass Aftercare Kit
98945A-NA
** Colour code must be specified when ordering.
(eg: white -0, black -BL, metallic -SHP, satin -SS)
M5x4 Grub Screw
1459277-CP
VALENCIA ELITE Corner Sliding Shower
Scan the QR barcode on the packaging or underside of top caps to identify the product SKU and date of manufacture.
!
CONTACT AND WARRANTY INFORMATION
NEW ZEALAND
Kohler New Zealand Limited
0800 100 382
AUSTRALIA
englefield.com
info@englefield.co.nz
englefield.co.nz
Page 15 englefield.co.nz
1371374-A02-B October 2023