Kohler POPLIN K-75881T User manual

-1-
POPLIN
INSTALLATION INSTRUCTIONS
CABINET
K-75881T/K-75854T
BEFORE YOU BEGINBEFORE YOU BEGIN
·
·
·
·
·
·
·
Please read these instructions carefully to familiarize
yourself with the required tools, materials, and installation
sequences. Follow the sections that pertain to your
particular installation. This will help you avoid costly
mistakes. In addition to proper installation, read all
operating and safety instructions.
All information in these instructions is based upon the
latest product information available at the time of
publication. Kohler China. reserves the right to make
changes in product characteristics, packaging, or
availability at any time without notice.
These instructions contain important care, cleaning, and
warranty information-
bathroom cabinet adopts
wood-based panel
Turn off the water supply.
The pluming installation must comply with Water Supply
Regulations/Bye-laws, Building Regulations or any
particular regulations and practices, specified by the local
water company or water undertakers. The installation
should be carried out by a plumber.
Before installation carefully inspect the new fixture for any
signs of damage.
please leave instructions for the
consumer.
POPLIN natural birch wood and
E1 grade birch of high quality, and with
further processing, its harmful emissions will be less than
1.5mg/L.
·This product complies with GB 24977-2010.
·
·
·
·
·
·
·
·
-
E1
1.5mg/L
GB 24977-2010
ORDERING INFORMATION
This installation covers the following products in the POPLIN
range:
POPLIN Cabinet 914mm....................................K-75881T
POPLIN Cabinet 1220mm..................................K-75854T
914mm.............................................K-75881T
1220mm...........................................K-75854T
SAFETY WARNINGS
Kohler products are precision-engineered and should give
continued superior and safe performance, provided:
1. They are installed, commissioned, operated and
maintained in accordance with the recommendations given
in this Manual.
2. Periodic attention is given, as necessary, to maintain the
product in good functional order. Recommended
guidelines are given in the section.
Carefully inspect the new fixture for any signs of damage.
When installing Kohler Products, manufacturers guidelines for
power tool safety should be followed.
MAINTENANCE
1.
2.
KOHLER CHINA INVESTMENT CO., LTD NO.158, JIANG CHANG SAN ROAD,
JING'AN DISTRICT, SHANGHAI, PRC POST CODE: 200436
( ) 158 200436
©
©
Copyright Kohler China Investment Co., Ltd. 2017
2017
1261214-T01-B

-2-
ROUGHING-IN
UNIT : mm
K-75881T
Cabinet 914mm
914mm
K-75854T
Cabinet 1220mm
1220mm
INSTALLATION
A. Install Washbasin Cabinet
Install the services.
Hot (H) and Cold (C) inlets must be connected to the correct
inlet pipes.
Install the drain in accordance with the manufacturer's
instructions.
We suggest using P-trap drain. Connect P-trap pipe with
washbasin drain.
Make sure a watertight seal exisits on all
washbasin drain connections.
Provide access to the plumbing
connections for future plumbing maintenance.
The hot and cold water supplies must be installed
with isolating valves.
CAUTION !
CAUTION !
NOTE
A.
(H) (C)
P
Fig.2
2
Reference Value
Kohler reserves the right to change marked dimensions without prior notice.
Fig.1
1
914
556
556
825
825
1220
1261214-T01-B

Fig.3
3
1. 3
1. Place the cabinet on the floor. Fix adjustable feet as shown
in Fig.3. (Put carton or foam on the floor first to prevent
scratching the cabinet.)
2. Put the cabinet upright and place it at a desired position in
the bathroom. Adjust the adjustable feet to make the
cabinet level, as shown in Fig.4.
Make sure the two feet in the middle contact with
ground.
Note:
2.
4
Fig.4
4
3. Fix handles as shown in Fig.5. 3. 5
-3-
Go Up Go Down
Fig.5
5
1261214-T01-B

-4-
Install the Synthetic Top
Note: Please refer to the installation instructions of synthetic
top for its installation. To protect the cabinet from
dampness, please apply silicone sealant where the
synthetic top and the cabinet connect.
Fig.7
7
5. 7
6.
5. Adjust the hinge cover in 3 direction to make sure the door
is level. As shown in Fig.7.
6. Place the hinge cover and plastic cover.
Fig.6
6
4. 6
4. Adjust position of the adjustable shelf as shown in Fig.6.
abc
de
Loosen the clip. Lift the shelf to remove it. Adjust position of the shelf support.
Press down the shelf. Tighten the clip.
1261214-T01-B

-5-
2. S
U
2. Floor drainage (S-Trap)
Please install the drain assembly and faucet as shown.
Please set the water supply and drainage position
according to the suppliers instructions. You can put the
pipe into the U notch.
Fig.9
9
Faucet
Supply Lines
Shut-off Valve
Drain Assembly
Ripple Pipe
Outlet
Fig.8
8
1. (P )
/UU
Connect Drainage
1. Inwall drainage (P-Trap)
Please install the drain assembly and faucet as shown.
Please set the water supply and drainage position
according to the suppliers instructions. You can put the
pipe into the U notch.
Faucet
Supply Lines
Shut-off Valve
Drain Assembly
1261214-T01-B

1.
2.
3.
4.
5.
6.
7.
USER MAINTENANCEUSER MAINTENANCE
Warning! Risk of product damage.
1.
2.
3.
4.
5.
6. Please do not sit, lean or step on the basin cabinet.
7. If any fixtures caused by abnormal reasons, Kohler China
can supply paid replacement for service parts caused by
abnormal reasons as shown in the Service Parts Page in
the limited duration of warranty.
Many cleansers contain abrasive and chemical substance
which is not suitable for cleaning stainless steel, enamel,
plating or plastic products. You may use mild cleansers or
soaps to clean the surfaces. Wipe any splashes of cleaner
solutions from the surface with clean soft cloth.
Maintain ventilation in the bathroom, and separate the dry
area from the damp one if conditions permit. Try to open
the door and windows of the bathroom and maintain good
ventilation.
Kohler bathroom cabinet are dealt with strict procedures
for damp-proof, whose good damp-proof function ensures
good performance even in bathroom of huge humidity. Yet
do not splash and pour water directly on the bathroom
cabinet. Make sure that the bathroom is not over damp
and wipe any splashes from surfaces immediately.
Maintenance of door board: Clean and wipe door board
regularly, and wipe the condensation vapor with dry and
soft cloth.
Ensure that electrical connections for appliances such as
head lamp is insulated wipe mirror surface with chamois
regularly to guarantee the persistent excellent performance.
-6-
1261214-T01-B