Kuryakyn 3765 User manual

PARTS INCLUDED
1 Stereo Accent
1 Stereo Cover
1 Alcohol Pad
1 Installation Instructions
Please read and understand entire instructions before starting installation.
THANK YOU FOR CHOOSING KÜRYAKYN!
IN ORDER TO PROTECT YOU AND OTHERS FROM POSSIBLE INJURY
AND/OR PROPERTY DAMAGE OR LOSS, PLEASE PAY CLOSE ATTENTION
TO ALL INSTRUCTIONS, WARNINGS, CAUTIONS AND ATTENTION NOTES
REGARDING THE USE AND CARE OF THIS PRODUCT.
WARNING! THIS INDICATION ALERTS YOU TO THE FACT THAT IGNORING THE
CONTENTS DESCRIBED HEREIN CAN RESULT IN POTENTIAL DEATH OR
SERIOUS INJURY.
CAUTION! This indication alerts you to the fact that ignoring the contents described herein
can result in potential injury or material damage.
ATTENTION! This indication alerts you to the fact that ignoring the contents described herein
may negatively affect product performance and functionality.
STRICTLY OBSERVE THE FOLLOWING GUIDELINES IN ORDER TO USE THE
PRODUCT PROPERLY AND AVOID POTENTIALLY DANGEROUS ACCIDENTS.
PROCEDURE
STEP 1 Read and understand all steps in the instructions before starting the installation. Park
the motorcycle on a hard, level surface; turn off the ignition and allow the engine to cool.
STEP 2 Test fit the Stereo Accent to the inner fairing.
NOTE It may be helpful to remove the Stereo Cover before test fitting
STEP 3 Mark the location of best fit using masking tape. This will help in final installation.
ATTENTION! The adhesive will not bond correctly if applied at temperatures less than 50°F. Do
not attempt this installation in temperatures less than 50°F.
STEP 4 Clean the entire mounting area on the inner fairing with the included alcohol pad.
Wipe the area completely dry with a clean cloth.
ATTENTION! Ensure the area of installation is free of grease, oil, dirt or other debris to ensure
proper adhesion. Küryakyn WILL NOT issue a warranty on any parts lost due to improper
installation.
3765-11HD-1209
STEREO ACCENT 3 7 6 5
-cont.-
FITS: '96-UP ELECTRA GLIDES, STREET GLIDES AND TRIKES

INSTALLATION
STEP 5 Rub the tape backing on the Stereo Accent to activate the adhesive. Remove the tape backing
and apply the Accent to the inner fairing.
STEP 6 Press and hold the Accent in place for one minute. Full bonding strength will occur in 24 hours.
STEREO COVER
STEP 1 To install the Stereo Cover, hook the top of the cover under the Stereo Accent and press
the lower portion of the Cover until it snaps in to place.
STEP 2 To remove the Stereo Cover, pull outward on the tabs at the bottom. The Cover should
snap out of place.
PAGE
2
STEREO ACCENT
PIC. 1