Kuryakyn 8617 User manual


  1 ForkBraceAssembly,including:
  1 CenterBridge
  2 OuterClamp
  2 InnerClamp
  4 1/4-20x7/8”BSCSFastener,StainlessSteel
  4 1/4-20x7/8”SHCSFastener.StainlessSteel
  1 InstallationInstructions
Please read and understand entire instructions before starting installation.


Itistheinstallers’responsibilitytomakesureallfasteners(includingpre-assembled)are
tightenedbeforeoperationofmotorcycle.Küryakynwillnotwarrantycomponentsthatare
lostduetoimproperinstallation.Periodicmaintenancemayberequired.

Allenwrenches.

 Coverthefrontfenderwithatoweltopreventscratches.
 Removethefourfastenerssecuringthecenterbridgetotheinnerandouterclamp
assemblies.Removethefastenerssecuringtheinnerandouterclampassembliestogether.
SeePIC.1.

 Placeaninnerandouterclampjustbelowthedustcapontherightfork.Besure
toorienttheinnerclampwiththe“ears”onthebottom.Looselysecurewiththeprovided
fasteners.SeePIC.2.Repeatfortheoppositeside.




8617-11HD-0806
    













 Installthecenterbridgeoverthetwoclampassemblies.Besurethereisclearancebetween
thebottomofthecenterbridgeandthetopofthefender.SeePIC.3.Adjustthepositionoftheclamps,if
necessary.

 Looselysecurethecenterbridgewiththeprovidedfasteners.Squareuptheentire
braceassemblybetweentheforksandthentightenthefastenerssecuringtheinnerandouter
clamps.Tightenthefrontfastenersfirst,thentherearfasteners.
 Tightenthefourfastenersonthecenterbridge.
Ride On!


 




