Leviton 71I00-1 Mounting instructions

HLC LOAD CONTROL MODULE
Cat. No. 71I00-1
Installation Instructions and User’s Guide
INSTALLATION ENGLISH
DI-021-OA711-00A
(71I00-1)
WARNINGS AND CAUTIONS
•TO AVOID FIRE, SHOCK, OR DEATH; TURN OFF POWER at circuit breaker or fuse and test that power is off before wiring!
•If you are unsure about any part of these instructions, consult an electrician.
•To be installed and/or used in accordance with appropriate electrical codes and regulations.
•Use this device with copper or copper-clad wire only.
•For indoor use only.
•SAVE THESE INSTRUCTIONS.
LEVITON LIMITED WARRANTY
Leviton warrants to the original consumer purchaser and not for the benefit of anyone else that products manufactured by Leviton under the Leviton brand name (“Product”) will be free
from defects in material and workmanship for the time periods indicated below, whichever is shorter: • OmniPro II and Lumina Pro: three (3) years from installation or 42 months from
manufacture date. • OmniLT, Omni IIe, and Lumina: two (2) years from installation or 30 months from manufacture date. • Thermostats, Accessories: two (2) years from installation or
30 months from manufacture date. • Batteries: Rechargeable batteries in products are warranted for ninety (90) days from date of purchase. Note: Primary (non-rechargeable) batteries
shipped in products are not warranted. Products with Windows® Operating Systems: During the warranty period, Leviton will restore corrupted operating systems to factory default
at no charge, provided that the product has been used as originally intended. Installation of non-Leviton software or modification of the operating system voids this warranty. Leviton’s
obligation under this Limited Warranty is limited to the repair or replacement, at Leviton’s option, of Product that fails due to defect in material or workmanship. Leviton reserves the
right to replace product under this Limited Warranty with new or remanufactured product. Leviton will not be responsible for labor costs of removal or reinstallation of Product.
The repaired or replaced product is then warranted under the terms of this Limited Warranty for the remainder of the Limited Warranty time period or ninety (90) days, whichever
is longer. This Limited Warranty does not cover PC-based software products. Leviton is not responsible for conditions or applications beyond Leviton’s control. Leviton is
not responsible for issues related to improper installation, including failure to follow written Installation and operation instructions, normal wear and tear,
catastrophe, fault or negligence of the user or other problems external to the Product.
FOR CANADA ONLY
For warranty information and/or product returns, residents of Canada should contact Leviton in writing or by telephone.
DESCRIPTION
The Model 71A00-1 HLC Load Control Module is a remote controlled heavy duty switch which may be used to operate 120VA or 240VAC electrical appliances, such as water heat-
ers, pool pumps, baseboard heaters, branch lighting loads, etc. It can be controlled locally by using the rocker switch or remotely by a UPB powerline signal.
INSTALLATION
Install according to Figure 1 or Figure 2. The Model 71A00-1 contains a 40A00-1 HLC 15A Relay Switch. Refer to the instruction sheet for the 40A00-1 provided for additional
information regarding safety, operation, and programming.
Figure 1
Connecting a 120VAC Device
CAUTION
BLAC
K
WHITE
RED
GREEN
SINGLE
BREAKE
R
120VA
C
LOAD
WEB VERSION
Shop for Power Metering products online at: 1.800.561.8187
www.PowerMeterStore.ca

FCC Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Copyright and Trademark Information
This document and all its contents herein are subject to and protected by international copyright and other intellectual property rights and are the property of Leviton
Manufacturing Co., Inc, its subsidiaries, affiliates and/or licensors. © 2013 Leviton Manufacturing Co., Inc. All rights reserved.
Use herein of third party trademarks, service marks, trade names, brand names and/or product names are for informational purposes only, are/may be the trademarks of their
respective owners; such use is not meant to imply affiliation, sponsorship, or endorsement.
No part of this document may be reproduced, transmitted or transcribed without the express written permission of Leviton Manufacturing Co., Inc.
© 2013 Leviton Mfg. Co., Inc. DI-021-OA711-00A
CAUTION
BLAC
K
WHIT
E
RED
GREEN
DOUBLE
BREAKER
240VAC
LOA
D
L1
L2
N
Figure 2
Connecting a 240VAC Device
WEB VERSION
Shop for Power Metering products online at: 1.800.561.8187
www.PowerMeterStore.ca