Leviton D8000 User manual

STEP 3
STEP 4
STEP 2
INSERT THE WIRED CONNECTOR THROUGH THE HOLE IN
THE BACK OF THE WALL STRAP. ATTATCH THE WALL
STRAP TO THE ELECTRICAL BOX AS SHOWN, USING (2)
6-32 X 1" SCREWS PROVIDED.
Installation Instructions
LOCATE FEMALE CONNECTOR PROVIDED
AND TERMINATE WIRES AS SHOWN.
STEP 1
LOCK }
6
TWISTED PAIR
OPTIONAL CONNECTIONS
FOR TERMINATION OF THE LAST DEVICE
IN THE RUN, TIE PINS 2 & 5 TOGETHER.
+12VDC
REM-
COM
TERM
NOTE:
REM+
2
PIN1
3
4
5
}
D8000
Entry Station
RETAINING SCREW ACCE
S
TURNED ALL THE WAY IN (CLOCK-WISE)
ON THE INSIDE OF THE WALL PLATE BY TUR
N
USE A #1 PHILLIPS SCREWDRIVER WITH A 0.1
2
TO SEAT THE RETAINING SCREW INTO THE S
L
IT COUNTER CLOCKWISE. SCREW SHOULD B
E
BEFORE WALL PLATE IS SET INTO PLACE.
TURNED OUT ONLY UNTIL SNUG.
ROTATE THE ASSEMBLY BACK INTO PLACE.
HOOK THE TOP OF THE WALL PLATE OVER
THE ANGLED TAB ON THE WALL STRAP, AND
STEP 5
RETAINING SCREW SHOULD BE
PLUG CONNECTOR ONTO BACK OF THE BUTTON ASSEMBLY
AS SHOWN. PUSH THE WIRE INTO THE WIRE
WAY IN BETWEEN THE SHROUD AND THE BACK
OF THE WALL BOX. ENSURE THE CORRECT LUMA-
NET ID DIP-SWITCH SETTING PRIOR TO INSTALLATION.
to return upon demand.
by the recipient constitutes an undertaking by
with the understanding that acceptance or review
MANUFACTURING COMPANY, INC. It is disclosed
exclusive PROPRIETARY property of LEVITON
The information in this document is the
which disclosed. This document is loaned subject
or in part, for any purpose other than that for
duplicate, copy, or use the information, in whole
strict confidence, and (2) not to disclose,
Copyright 2002 LevitonMfg, Co. Inc.
the recipient; (1) to hold this information in
C
THIRD
ANGLE PROJECTION
DRAWING INTERPRETATION PER ASME
Y14.5 1994
Unpublished, All Rights Reserved.