Leviton DL057-D0Z User manual

• Range up to 75 feet between wireless devices.
• Installs into any single gang device back-box.
• Supports multi-gang installations.
• Multiple devices may be used within the same room for control from
multiple locations or to control multiple loads.
• Each room requires at least one room controller.
• Requires Decora®faceplate, sold separately.
• DL057 uses 0-10V DC low-voltage control wires which may be
installed using Class 1 or Class 2.
INSTALLATION NOTE (DL057): 0-10V Control Wiring - Connect the
Violet wire to the + 0-10V line and the Pink wire to the 0-10V common
using Class 1 or Class 2 wiring methods as indicated in these instructions,
ballast/xture/driver instructions or ballast/xture/driver label markings.
Observe all requirements of any authority having jurisdiction with respect
to wire type, sleeving, isolation methods, and the like.
NOTE: Depending on date of manufacture, the pink 0-10V wire may be gray.
The wireless DL057 Wall Station Dimming Room Controller and DL05S
Wall Station Switching Room Controller are designed to be used to
coordinate and control compatible ZigBee-enabled lamps, xtures, load
controllers and wireless sensors within a room. The Wall Station Room
Controllers can directly control lighting loads and/or be expanded with
other wireless devices. It provides all energy management functionality as
required by code and as desired by the user. All aspects of the system can
be congured to meet the specic needs of the end user and their
application. All conguration is made using the LuminaTM RF SA app from
your smartphone or other BluetoothTM enabled AndroidTM or iOSTM device.
WARNINGS:
• TO AVOID FIRE, SHOCK, OR DEATH; TURN OFF POWER AT CIRCUIT
BREAKER OR FUSE AND TEST THAT POWER IS OFF BEFORE WIRING!
• To be installed and/or used in accordance with appropriate electrical codes
and regulations.
• If you are unsure about any part of these instructions, consult an electrician.
CAUTIONS:
• Use this device with copper or copper-clad wire only.
• For indoor applications only.
• To avoid damage to the product, DO NOT use disinfecting products, including
foggers, sprays or other types of atomized cleaning agents.
• DO NOT spray liquid onto the product.
• To clean, use a damp cloth with mild soap.
• SAVE THESE INSTRUCTIONS.
WARNING: TO AVOID FIRE, SHOCK, OR DEATH; TURN OFF POWER AT
CIRCUIT BREAKER OR FUSE AND TEST THAT POWER IS OFF BEFORE WIRING!
When room controller is also powering load:
1. Strip 3/4 in. and connect as per wiring diagram.
Ensure wires are rmly attached and there is no exposed copper.
Before Installation
Product Description
Installation
Wall Station Dimming Room Controller Dimmers & Switch
Cat. No. DL057-D0Z, Ratings: 120-277V AC, 0-10V
Cat. No. DL057-30Z, Ratings: 347V AC, 0-10V
Cat. No. DL05S-D0Z, Ratings: 120-277V AC, Switch PK-A3300-10-00-2C
Line
120/277VAC,
50/60Hz.
Blue
White
Hot (Black)
Black
Neutral (White)
White
Load
Green
Ground
To release, push sides. Line up and press in to attach.
Black
Blue
Green
White
Load
Neutral
Line (Hot)
Ground
0-10 VDC
Ballast/LED Driver
Black Blue Black
Hot (Black)
Pink
Neutral (White)
Line
Electrical Box
White White
Sleeve
Violet
Connectors
Green
Ground
Switch DL05S
Switch DL05S
Dimmer DL057
Dimmer DL057
2. Gently place the wires and your device into the wall box and attach
with screws provided.
4. If desired, change faceplate color.
5. Install Decora wallplate.
White Load
Neutral
Line (Hot)
Ground
Blue
Green
Violet
Pink
Black
3. Restore power and test ON/OFF operation. Locator light should be ON
when switch power is turned OFF.
INSTALLATION INSTRUCTIONS ENGLISH
WEB VERSION

© 2023 Leviton Mfg. Co., Inc. For Technical Assistance Call: 1-800-824-3005 (USA Only) or 1-800-405-5320 (Canada Only) www.leviton.com
FCC COMPLIANCE STATEMENT:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures: Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC CAUTION:
Any changes or modications not expressly approved by Leviton Manufacturing Co.,
Inc., could void the user’s authority to operate the equipment.
FCC SUPPLIER’S DECLARATION OF CONFORMITY:
Wireless Wall Station Room Controllers DL057-D0Z, DL057-30Z, DL05S-D0Z,
manufactured by Leviton Manufacturing Co., Inc. 201 North Service Road, Melville,
NY 11747. www.leviton.com. This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:(1) This device may not cause
harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
IC STATEMENT
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Conguration and Programming
• System Conguration is performed using the LuminaTM RF SA application, downloadable from Google PlayTM or the App StoreTM, using any Bluetooth
enabled Android or iOS Device. Use the application to:
a. Manually add/remove xtures, keypads, load controllers, sensors, switches or dimmers to the room for an advanced intelligent lighting control system.
b. Change Sensor Parameters like Sensitivity, Timeout, target light level.
c. Create user dened groups of xtures and loads.
d. Dene Scenes (Meeting, Presentation, Lunch, Dinner, Test, etc.).
• Factory Default – resets device to out of the box state
a. Push top or bottom of paddle for approximately 20 seconds until the locator light ashes AMBER the second time.
b. Release paddle.
c. Locator light will alternate between GREEN/AMBER while device is resetting, and turn OFF when complete.
d. When complete, device will reboot. Locator light will blink GREEN slowly while looking for an open network.
NOTE: Renement is required to the initial conguration. Based on some room geometries, the system may not be able to accurately congure itself
automatically. The LuminaTM RF SA smart device application will lead you through this process.
LOCATOR LIGHT - ON when
switch is OFF so you can nd
your control.
PADDLE BOTTOM
- OFF
PROGRAMMING
Can be performed by pressing
the top or bottom of switch.
PADDLE TOP
- ON
RF EXPOSURE AND CO-LOCATION:
To comply with FCC OET Bulletin 65 and ISED RF exposure limits for general
population / uncontrolled exposure this device should be installed and operated with
a minimum distance of 7.9 inches (20 cm) between the radiator and your body. This
transmitter must not be co-located or operated in conjunction with any other antenna
or transmitter.
TRADEMARK DISCLAIMER: Leviton, Decora and Lumina are Leviton trademarks
and Zigbee, iOS, Google Play, App Store, Android, and Bluetooth are the trademarks
of their respective owners.
LOCATOR LIGHT- ON when
switch is OFF so you can nd
your control.
ROCKER DOWN
- Tap to lower 12%.
(deault rate)
Push and hold to lower
to the desired light level.
BRIGHTNESS INDICATORS
LEDs indicate brightness
level.
ROCKER UP
- Tap to raise 12%
(default rate).
Push and hold to raise
to desired light level.
PADDLE TOP
- ON
PADDLE BOTTOM
- OFF
Switch DL05S Dimmer DL057
SPECIFICATIONS
Catalog No. DL05S-D0Z DL057-D0Z DL057-30Z
Input Voltage/Frequency 120-277VAC, 50/60Hz. 347VAC, 60Hz
Input Current
120V Standby: 0.2W
Max: 0.5W+Load Current -
277V Standby: 0.3W
Max: 0.6W+Load Current -
347V - 0.5W+Load
Current
Load Ratings
LED, CFL, Electronic Ballast @ 120V 8A -
LED, CFL, Electronic Ballast @ 277V 5A -
LED, CFL, Electronic Ballast @ 347V - 4A, 1388VA
Magnetic Ballast @ 120V 10A
Magnetic Ballast @ 277V 10A
Magnetic Ballast @ 347V - 3.45A, 1200VA
Resistive, Tungsten @ 120V 6.67A -
Resistive, Tungsten @ 277V 6.67A -
Resistive, Tungsten @ 347V - 6.67A
Motor @ 120V 1/4Hp (FLA 5.8A) -
Motor @ 277V 1/3Hp (FLA 3.0A) -
Motor @ 347V - 1/4Hp
IP Rating IP10
Network Connections IEEE 802.15.4, 2.4Ghz, wireless, mesh network up to 75'
range between devices.
Operating Temperature 0°C - 40°C (32°F - 104°F)
Storage Temperature -40°C to 85°C
UL Pollution Degree 2
UL Impulse Voltage 6000V
Purpose of Control Operating Control
Action Control Type 1
NOTE: Dash indicates model not rated for use.
LIMITED 5 YEAR WARRANTY AND EXCLUSIONS
Leviton warrants to the original consumer purchaser and not for the benet of anyone else that this product at the time of its sale by Leviton is free of defects in materials and workmanship under normal and proper
use for ve years from the purchase date. Leviton’s only obligation is to correct such defects by repair or replacement, at its option. For details visit www.leviton.com or call 1-800-824-3005. This warranty
excludes and there is disclaimed liability for labor for removal of this product or reinstallation. This warranty is void if this product is installed improperly or in an improper environment, overloaded, misused,
opened, abused, or altered in any manner, or is not used under normal operating conditions or not in accordance with any labels or instructions.There are no other or implied warranties of any kind,including
merchantability and tness for a particular purpose, but if any implied warranty is required by the applicable jurisdiction, the duration of any such implied warranty, including merchantability and tness for
a particular purpose, is limited to ve years.Leviton is not liable for incidental,indirect,special, or consequential damages, including without limitation, damage to,or loss of use of, any equipment,
lost sales or prots or delay or failure to perform this warranty obligation. The remedies provided herein are the exclusive remedies under this warranty, whether based on contract, tort or otherwise.
FOR CANADA ONLY
For warranty information and/or product returns, residents of Canada should contact Leviton in writing at Leviton Manufacturing of Canada ULC to the attention of the Quality Assurance
Department, 165 Hymus Blvd, Pointe-Claire (Quebec), Canada H9R 1E9 or by telephone at 1-800-405-5320.
6. Using the LuminaTM RF SA app, set up device and
congure your system.Using your system, you can
program different functionality, such as pushing
the top of the paddle for a presentation scene or
pushing the bottom of the paddle to turn it OFF.
WEB VERSION