Life Fitness Club Series User manual

CLUBSERIESDUMBBELLRACK
WITHSADDLES
Part # 7153401
RevA. Revision:7/09/011
ASSEMBLY INSTRUCTIONS

PARTS LIST
PART #
71526
71512
3203201
3102905
3108411
3102514
KEY
1
2
3
4
5
6
QTY
2
2
40
8
40
56
KEY
7
8
9
10
OR
PART #
6866701
3102807
6866601
6866602
6866603
DESCRIPTION
3/8” RH WASHER
3/8” LOW HEIGHT LOCK NUT
BLACK RH CAP
WHITE RH CAP
PLATINUM RH CAP
QTY
56
48
48
8
8
DESCRIPTION
DUMBBELLTIER
TIER SUPPORT
WEIGHTRESTSADDLE
3/8 X 3-3/4” BOLT
3/8 X 1-1/4” FLAT HEAD BOLT
3/8” SAE WASHER
BOLT LENGTH
Tools Required forAssembly
2
NOTE:BOLTLENGTH IS MEASURED FROMTHEUNDERSIDEOFTHEHEADOFTHEBOLT.
Bolt Length Ruler
0123456
1/2 1/2 1/2 1/2 1/2 1/2
* Rubber mallet or hammer
* 9/16” wrench
* Ratchet with 9/16” socket
* 7/32”Allen wrench

3
4 3/8 X 3-3/4” BOLT 8
3/8” LOW
HEIGHT LOCK
NUT
6
3/8” SAE
WASHER
10
RH CAP
(BLACK/WHITE/PLATINUM)
7
3/8” RH WASHER
9
5 3/8 X 1-1/4”
FLAT HEAD BOLT

STEP 1:
FIGURE 1
4
• SECURELY assemble the DUMBBELL TIERS (1) to the TIER SUPPORTS (2) using eight RH CAPS (10), eight BLACK RH
CAPS (9), eight 3/8 X 3-3/4” BOLTS (4), sixteen 3/8” SAE WASHERS (6), sixteen 3/8” RH WASHERS (7) and eight 3/8”
LOW HEIGHT LOCK NUTS (8) as shown in FIGURE 1.
9 BLACK
4 3/8 X 3-3/4”
7
6
1
8
2
10
STEP 2:
FIGURE 2
• SECURELY assemble forty WEIGHT REST SADDLES (3) to the DUMBBELL TIERS (1) using forty BLACK RH CAPS (9),
forty 3/8 X 1-1/4” FLAT HEAD BOLTS (5), forty 3/8” SAE WASHERS (6), forty 3/8” RH WASHERS (7) and forty 3/8” LOW
HEIGHT LOCK NUTS (8) as shown in FIGURE 2. NOTE: Before tightening each WEIGHT REST SADDLE (3) make sure
SADDLE is parallel with DUMBELL TIERS (1).
9
7
8
3/8 X 1-1/4” 5
3
1
6

Clean:
• Upholstery with mild soap and water.
• Guide rods with a cotton cloth.
• Hand grips with mild soap and water.
• Frame damage can be repaired with touch-up paint can be purchased from your LifeFitness customer service representative at
[phone].
Inspect:
• Cables for wear or damage and proper tension (should not exceed 3/4” deflection.) Pay close attention at bends and attachment
points.
• Hardware should be checked for looseness. Tighten as required.
• Frames should be inspected for wear or damage.
• Hand Grips should be checked for wear or damage
Lubricate:
• Lube the Guide Rods. Apply the lubricant to a cotton cloth, then run the cotton cloth up and down the guide rods as needed. Do not
spray lubricant directly on the Guide Rods.
PREVENTATIVE MAINTENANCE TIPS
There is a risk assumed by individuals who use this type of equipment. To minimize risk, please
follow these rules:
2. Do not allow minors or children to play on or around this equipment.
1. Inspect equipment daily. Tighten all loose connections and replace worn parts immediately.
Failure to do so may result in serious injury.
3. Exercise with care to avoid injury.
4. Consult your physician before beginning any exercise program.
5
Thankyou for purchasingtheLifeFitnessCLUB SERIES DUMBBELLRACKWITHSADDLES. Ifunsure
ofproper use of equipment, callyour local LifeFitness distributor or callthe LifeFitness customer service
department at [phone].
CAUTION-PLEASE READ
Action DAILY WEEKLY QUARTERLY BI-ANNUALLY AS NEEDED
CLEAN
Upholstery X
Guide Rods X
Hand Grips X
INSPECT
Visual Overall X
Cables X
Hardware X
Frame X
Hand Grips X
LUBRICATE
Guide Rods X
WARRANTY INFORMATION
10YEARS STRUCTURUALFRAME
3 YEARS PILLOWBLOCKS, PULLEYS,WEIGHTPLATESANDGUIDE RODS
1YEAR CABLES
90 DAYS UPHOLSTERY