Life Fitness CS45X User manual

CLUB SERIES 45 DEGREE
BACKEXTENSION
Part # 7320201
Rev.C Revision: 11/18/021
ASSEMBLY INSTRUCTIONS

PARTS LIST
PART #
ACU04-0001
ACU04-0002
ACU04-0003F
ACU02-0002
ACUP07-0001
ACU04-0017
ACU04-0003R
ACUP05-0002
DA1C03807716NU
KEY
1
2
3
4
5
6
7
8
9
QTY
1
1
1
1
2
1
1
2
4
KEY
10
11
12
13
14
15
16
OR
PART #
ACUP05-0007
DA1C03806216NU
DA1C03809316NU
DB2E03807200U
DC120010510B
ACUP05-0009
ACUP06-0021
ACUP06-0021
DESCRIPTION
5/16X1/2”SHOULDERBOLT
3/8X62mmBOLT
3/8X93mmBOLT
3/8”LOWHEIGHTLOCKNUT
3/8”SAEWASHER
3/8”RHWASHER
WHITERHCAP
PLATINUMRHCAP
QTY
1
2
4
8
18
18
18
18
DESCRIPTION
FRAME
HIPPADADJUST
SUPPORTFRONT
FOOTPLATE
HIPPAD
PADADJUST
SUPPORTREAR
3/8X66mmFLATHEADBOLT
3/8X77mmBOLT
BOLT LENGTH
Tools Required forAssembly
2
NOTE:BOLTLENGTHISMEASUREDFROMTHE UNDERSIDE OFTHE HEAD OFTHEBOLT.
Bolt Length Ruler
* 9/16” wrench
* Ratchet with 9/16” socket
* 6mm Allen Wrench (supplied)
* 4mm Allen Wrench (supplied)
01
1/2 1/2 1/2 1/2 1/2 1/2
23456
10 20 30 40 50 60 70 80 90 100 110 120 130 140 150

3
13
3/8” LOW
HEIGHT LOCK
NUT
14
3/8” SAE
WASHER
16
RH CAP
(WHITE/PLATINUM)
15
3/8” RH
WASHER
9 3/8X77mmBOLT
12 3/8X93mm BOLT
8 3/8X 66mm FLATHEADBOLT
10 5/16 X 1/2” SHOULDER HEAD BOLT
11 3/8X62mmBOLT

STEP 1:
FIGURE 1
4
• SECURELYassembletheFRONTand REAR SUPPORTS(3& 7) to the FRAME (1) using eight RH CAPS (16),four3/8X93mmBOLTS
(12), eight 3/8” SAE WASHERS (14), eight 3/8” RH WASHERS (15) and four 3/8” LOW HEIGHT LOCK NUTS (13) as shown in
FIGURE1.
16
13
3
1
3/8X93mm 12
1514
7

STEP 2:
FIGURE 2
5
• Pull back the SPRING PIN on the FRAME (1) and insert the PAD ADJUST (6) as shown in FIGURE 2.
1
6
4 13
16
14 15
3/8X 66mm FLATHEAD 8
SPRING PIN
• SECURELY assemble the FORMEDANGLE (4) to the FRAME (1) using two 3/8 X 66mm FLAT HEAD BOLTS (8), two 3/8” RH
WASHERS (15), two 3/8” SAE WASHERS (14), two 3/8” LOW HEIGHT LOCK NUTS (13) and two RH CAPS (16) as shown in
FIGURE2.
• SECURELY assemble the HIPPADADJUST(2) to the PADADJUST(6) using four RH CAPS (16), two 3/8 X 62mm BOLTS (11),four
3/8”SAEWASHERS(14), four 3/8” RHWASHERS (15) and two 3/8” LOWHEIGHT LOCK NUTS (13)as shown inFIGURE 2.
11 3/8X62mm
2

STEP 3:
FIGURE 3
6
6
10 5/16 X 1/2”
SHOULDER
BOLT
• SECURELY assemble one 5/16 X 1/2” SHOULDER BOLT (10) to the PAD ADJUST (6) as shown in FIGURE 3.

STEP 4:
FIGURE 4
7
2
3”
• SECURELYassemblethe two HIPPADS (5) totheHIPPADADJUST(2) using four RHCAPS(16), four 3/8 X 77mm BOLTS (9), four 3/
8” SAEWASHERS (14) and four3/8” RHWASHERS (15) as shownin FIGURE 4. (Notethethe directionofthehole patternonpad.)
9 3/8X77mm
5
16
14
15
SERIAL #
LOCATION

Clean:
• Upholstery with mild soap and water.
• Guide rods with a cotton cloth.
• Hand grips with mild soap and water.
• Frame damage can be repaired with touch-up paint can be purchased from your LifeFitness customer service representative at
[phone].
Inspect:
• Cables for wear or damage and proper tension (should not exceed 3/4” deflection.) Pay close attention at bends and attachment
points.
• Hardware should be checked for looseness. Tighten as required.
• Frames should be inspected for wear or damage.
• Hand Grips should be checked for wear or damage
Lubricate:
• Lube the Guide Rods. Apply the lubricant to a cotton cloth, then run the cotton cloth up and down the guide rods as needed. Do not
spray lubricant directly on the Guide Rods.
PREVENTATIVE MAINTENANCE TIPS
There is a risk assumed by individuals who use this type of equipment. To minimize risk, please
follow these rules:
2. Do not allow minors or children to play on or around this equipment.
1. Inspect equipment daily. Tighten all loose connections and replace worn parts immediately.
Failure to do so may result in serious injury.
3. Exercise with care to avoid injury.
4. Consult your physician before beginning any exercise program.
8
Thankyou for purchasing the LifeFitness CLUBSERIES45DEGREEBACK EXTENSION. If unsure of
properuseofequipment, call your local LifeFitness distributor or call the LifeFitness customer service
department at [phone].
CAUTION-PLEASE READ
Action DAILY WEEKLY QUARTERLY BI-ANNUALLY AS NEEDED
CLEAN
Upholstery X
Guide Rods X
Hand Grips X
INSPECT
Visual Overall X
Cables X
Hardware X
Frame X
Hand Grips X
LUBRICATE
Guide Rods X
WARRANTY INFORMATION
10YEARS STRUCTURUALFRAME
3 YEARS PILLOWBLOCKS,PULLEYS,WEIGHTPLATESANDGUIDERODS
1YEAR CABLES
90 DAYS UPHOLSTERY