Life Span Vertex ST-15 User manual

Product may vary slightly from the item pictured due to model upgrades.
Read all instructions carefully before using this product.
Retain this owner’s manual for future reference.
NOTE:
This manual should not be used to guide your purchasing decision. Your product, and the contents inside its carton, may vary
from what is listed in this manual. This manual may also be subject to updates or changes. Updated manuals are available
through our website at www.lifespanfitness.com.au
ST-15 Vertex 4 Level Commercial
Stair Climber Stepmill
USER MANUAL

2
TABLE OF
CONTENTS
I. Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 03
II. Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 05
III. Exploded Diagram . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 07
IV. Parts List . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 09
V. Assembly Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
VI. Operating Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
VII. Exercise Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23
VIII. Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25
IX. Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26
X. Hand Pulse Technology . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27
| TABLE OF CONTENTS

3
I. IMPORTANT SAFETY
INSTRUCTIONS
WARNING: Read all instructions before using this machine.
It is important your machine receives regular maintenance to prolong its useful life. Failing to
regularly maintain your machine may void your warranty.
DANGER: To reduce the risk of electric shock disconnect your stair climber from the electrical
outlet prior to cleaning and/or service work.
Do not use an extension cord: do not attempt to disable the grounded plug by using improper
adapters or in any way modify the cord set.
1. The machine is suitable for commercial and domestic use.
2. The stair climber is suitable for indoor (climate control) use only. It is not for suitable:
- for outdoor or high humidity; recommended operating temperature: 5-400C.
- does not allow water or other liquids to be splashed on the machine
- does not allow the placement or insertion of any foreign objects on the stair climber
3. Stair climber should be installed on solid, levelled surface with a safety space of 100-200cm.
4. Do not place equipment on thick carpet. If you have thick carpet, place a rubber mat over it first.
5. The stair climber should be used within the allowable range of voltage AC 110V-AC 240V.
6. Never operate the equipment if it has a damaged power cord or plug. When damaged, these must be
replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
7. Keep the cord away from heated surfaces.
8. Do not operate where aerosol spray products are being used or where oxygen is being administered.
Sparks from the motor may ignite a highly gaseous environment.
9. Never drop or insert any object into any openings.
10. All fixings should be checked before the equipment is used. Ensure to tighten any loose fixings.
11. All manuals relating to the use of the equipment should be retained for future reference.
12. Incorrect or overload training may cause the damage of the motor and controller, accelerate the
aging transmission system, even bodily injuries. Ensure to allow cool down periods.
13. If the equipment has abnormal sound or other abnormal conditions, please stop running
immediately and contact our after-sales department in time, or seek professional help.
14. Emergency stop: In the lower right corner of the stair climber installed with a photoelectric switch
(Sensor), if an object is detected the staircase will immediately stop.
Note: The photoelectric switch is a sensitive component. If there is dust or there is a deviation in the
IMPORTANT SAFETY INSTRUCTIONS |

4| IMPORTANT SAFETY INSTRUCTIONS
installation position, the "emergency stop" will be displayed on the display and the stair machine
cannot be used. Therefore, the surface of the photoelectric switch must be clean and the installation
position must be correct.
15. Check the stop button to ensure the brakes wont before use but pressing the start and stop button
and checking the emergency stop at the bottom.
USER SAFETY:
TECHNICAL STANDARDS:
1. Keep hands away from all moving parts.
2. Only one person at a time to use this equipment. Max load: 180kg
3. Ensure to hold onto the handrails for safety and start slow if it is your first time using this equipment.
4. This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
5. WARNING heat rate monitoring systems may be inaccurate. If you feel faint stop exercising
immediately.
6. Children should not be allowed on or around the equipment, even when not in use.
7. Children should be supervised to ensure that they do not play with this machine.
8. Loose fitting clothing or jewellery that could become an entanglement hazard should not be worn.
9. Training shoes should be worn when using the equipment.
10.Do not do exercise in 40 minutes after meal.
Input power supply voltage: AC 110V AC 240V
Time display range: 0:00 99:59
Height display range: 0.00 999.9m
Heat display range: 0 999 (Kcal)
Level display range: 0 15
Step number display range: 0 9999
Power cord specification: 10A AC250V
Running speed: 24 steps / minute 164 steps / minute

5
II. MAINTENANCE
1. Cleaning
• It is recommended that you clean the equipment before and after each training session. To remove
dust from the equipment, use a soft cloth to wet the following cleaning agents and then wipe all
exposed surfaces.
NOTE: Before using any cleaning agent to clean the fitness equipment, read and follow the
manufacturer’s instructions. Do not use a strong concentration of concentrate, or any acidic cleaner;
this type of cleaner will corrode the protective layer of the equipment. Use warm and slightly soapy
water. Do not spill or spray water or liquid onto any part of the equipment. Wait until the equipment is
completely dry before using the equipment.
• Vacuum around the equipment to prevent dust accumulation from affecting the operation of
the equipment. Use a soft nylon brush to clean the device recesses and foot pedals.
• Clean the area where the emergency stop sensors are to prevent the dust from triggering the sensors.
2. Daily Inspection
Check the equipment at least once a day for the following problems:
• Belt slip
•Loose fasteners
•Abnormal noise
•Any other signs that the equipment may need to be repaired.
the equipment. Use a soft nylon brush to clean the device recesses and foot pedals.
• Clean the area where the emergency stop sensors are to prevent the dust from triggering the sensors.
3. Weekly Maintenance
Perform the following maintenance tasks weekly:
• Use water or approved cleaning agents to clean the tracks and wheels.
• Use a vacuum cleaner or wet mop to clean the floor around the equipment.
• Test the console’s features, including heart rate monitoring.
• Check that the equipment is stationary on the floor. All feet of the equipment should be in firm contact
with the floor and the equipment should not be shaken or shaken when in use. If not, please re level.
• Tighten any loose bolts or fixings.
Relocation of Equipment
If you plan to move your equipment to a new location, look for adult help and use the right lifting
techniques. You may require 2 or more persons to help.