Lowenstein Medical LM Flow 100 Reference guide

1. Installation
Connect the
nozzle fitting to the
water chamber.
To insert the
water chamber, press
the lock with the
bottom of the water
chamber and slide the
water chamber onto
the heating plate until
the lock engages.
Connect the
water bag/water bottle.
Check the water
level in the water
chamber.
Connect the
heated tube system.
LM Flow 100 Brief Instructions for Use
Connect the
LM Flow 100 to
power.
Connect the
oxygen source (not
necessary if no
additional oxygen is
required).

2. Parameter setting
Select the
parameters using the
touchscreen.
Adjust the nasal
cannula.
3.At the end of therapy
Disconnect/shut
o the oxygen source.
Remove the tube system and disconnect the power.
Set the required
parameters (O2, flow,
temperature) using the
touchscreen/encoder.
Press the
Start/Stop key for
three seconds to start
the therapy.
Press the
Start/Stop key for
three seconds to end
therapy and start or
stop the drying mode.
0197
Import and Sales:
Löwenstein Medical
Arzbacher Straße 80
56130 Bad Ems
Germany
T: [phone]
F: [phone]
inf[email protected]
www.hul.de
Prolinx
Brehmstr. 56, 40239 Düsseldorf
Germany
Shenyang RMS Medical
No. 21, Gaoke Road, Hunnan New District, Shenyang
China