Lumex Splash Technical manual

Only continue if the light on the hand control is
constant or ashing green and if the battery has been
charged within the last 7-10 days.
When the seat reaches the top of the tub:
• ReleaseyourngerfromtheUPbutton;
• Sitonthesideapandrotateontotheseat;
• Extendyourfeetoutinfrontofyouandkeepyour
handsabovetheseat;
• PresstheDOWNbuttononthehandcontrol;
• Attachthehandcontrolandbatterytotheedgeof    
the tub or to a tiled wall.
Forconvenienceduringbathing,youmayraiseorlower
theseattoanydesiredheightbypressingtheUPor
DOWNbuttonandreleasingittostop.
Whenyouhavenishedbathing:
• Retrievethebatteryandhandcontrol;
• PresstheUPbuttonuntilthesideapsarelevel
withthetopofthetub;
• ReleasetheUPbuttonandmoveontothesideap;
• Turnwhileliftingeachlegoutofthetub;
• Drainthetub.
5. When you are not using the bath lift:
• Disconnectthebatteryandplaceoncharge;
• Storetheliftatthebottomofthetub.
Toremovetheliftfromthetub,placeitinits
lowest position and:
• Disconnectthebatteryfromthehandcontrol;
• Placethehandcontrolontheseat;
• Foldinthesideaps;
• Whileholdingthetopofthebackrest,pullthe
suction release tags on the rear suction feet then
tilt the bath lift forward (g 4);
• Releasethetagsonthefrontsuctionfeetandlift
thebathliftoutofthetub;
• Wrapthehandcontrolcableclockwisearound
the seat, positioning the cable coil under the
actuatorcasing;
• Looptheremainderofthecablearoundoneof
the tubes(g 5);
• Storethebathliftuprightoronitsside.
Tracks Hand control
Figure 3
Battery
Actuator casingCable coil
Figure 5
Figure 4
Top of
backrest
Suction
release tag
3

Operating instructions
Contents
Unpacking the bath lift
1.Unpackingthebathlift .............5
Before you start
2. Charging the battery . . . . . . . . . . . . . . . 5
3.Preparingthetubforinstallation .........6
4. Installing the bath lift . . . . . . . . . . . . . . . 7
Using the bath lift
5. Connecting the hand control . . . . . . . 8
6.Usingthebathlift ..................8
Removing and storing the bath lift
7. When the bath lift is not in use . . . 10
8.Removingthebathliftfrom
thetub............................10
9.Cleaning ..........................11
Warranties, maintenance & servicing
10. Maintenance and servicing . . . . . . . 11
11.Warranty ........................ 12
Symbols
12.Symbols .........................12
Technical data
13.Technicaldata....................13
Troubleshooting
14.Troubleshooting ..................15
Parts list
15.Accessories ......................18
16.Partslist..........................20
4

1. Unpacking the bath lift
Openthepackagingandensurethebathliftisnotdamagedandthatallpartsareincluded.Ifithas
beendamagedintransitorpartsaremissing,contactyoursupplierimmediately.
Insidetheboxyouwillnd:
 • Abathlift,completewithtwosideapsandhandcontrolattached(see g 1)
 • Abattery(see g 2)
 • Abatterychargerwithchargingcradleattached(see g 2)
Ifyourbathliftissuppliedwithoptionalsoftcovers,tthematthisstage
(seecoverttinginstructions).
Beforeinstallingorusingthebathliftforthersttime,ensureyouchargethebattery
(seesection2,“Chargingthebattery”below).
2. Charging the battery
Before rst operation of your bath lift or after long periods of non-use (typically 7-10 days),
fully charge the battery as follows. A at battery will take up to 2 hours to charge.
i) Slidethebatteryintothetracksonthechargingcradleuntilitclicksintoplace(see g 2).
ii) Plugthechargerintoasocket/outletoutsidethebathroomandswitchontheelectricitysupply
(ifapplicable).
iii) Thelightindicatoronthechargerboxwillinitiallyashinaquicksequenceofred,green,red,
green, before a constant red light appears to indicate charging is in progress (see g 2).
iv) Whenthebatteryhasbeenfullycharged,theredlightonthechargerboxturnstoaconstant
greenlight,whichindicatesthebatteryisreadyforuse.Werecommendchargingthebattery
aftereachbathwhereverpossibleandleavingitonchargeuntilyournextbath.Thebattery
cannot be overcharged.
v) Whenyouarereadytouseyourfullychargedbattery(seeparagraphiv),switchothesocket/
outletorremovethechargerfromthesocket/outlet,then ensure you disconnect the battery
from the charging cradle.(Thispreventsthebatterydischargingandwillresetthecharger
readyforitsnextuse.)
5
Diagrams for operation and explanation of use are on the
fold-out diagram sheet attached to the rear of this booklet

NOTE:
 • Donotchargeinthebathroomoranyhumidarea.Alwayschargeinadryarea,ensuringyour
handsaredryrst.
 •Donotcoverthebatteryorchargerwhilecharging.
 •Alwayschargeonahardsurface.
 •Duringcharging,thetemperatureofthechargerboxmayexceed40oC/104oF but will gradually
decreaseoncetheconstantgreenlightontheboxappears.Userswithsensitive/damagedskin
shouldtakecareandallowapproximately3hoursfromstartofchargingbeforehandlingthebox.
 •Ensurethatnometalobjectstouchthecontactsonthebattery,asthiswilldamagethebattery.
 •UseonlytheLumex®Splashchargersuppliedtochargethebatteryandfornootherpurpose.
3. Preparing the tub for installation
i) Removeanynon-slipmatsfromthetub.
ii) Ensurethebottomofthetubiscleanandsmooth,withnooilortubcleanerresiduesthatwill
preventthesuctionfeetfromsticking.
iii) Thesuctionfeetmaynotbesuitableintubsthathavebeenre-enamelledorthathaverippledor
texturedsurfaces.
iv) Itisessentialthatthesideaps(see g 1) do not catch under any obstructions such as integral
tub handles, handrails, soap dishes and faucets when rising. If your tub has integral handles
andthesideapsarelikelytocatch,optionalsideapprotectorsareavailable(seesection15,
“Accessories”).Thesehookoverintegraltubhandles (see g 3) and help guide the side aps
smoothlyoverthehandles.
v) Ensuretherearenooverheadobstructionsattherearofthetub,wherethebathliftwillbe
positioned(e.g.wall-mountedshelves/cupboardsorshowerxtures),astheymayinterferewith
theupwardmovementoftheseat.Wherepossible,removesuchobstructions.Alternatively,
thebathliftmustbeplacedfurtherforwardinthetubtoavoidtheobstruction(seesection4,
“Installingthebathlift”).
6