Makita JN1600 Manual

JN1600
Makita 1.6mm Nibbler
Voltage(V) Current(A) Continuous rating input
100 3.2 50/60 300 W
Soft steel plate 1.6mm
Maximum capacities Stainless steel 1.2mm
Cutting width(mm) 8mm
Prepared hole(mm) 18mm or more
inside 7mm
Outside 15mm
Strokes per minute 2200/min.
Overall length(mm) 245mm
Net weight(kg) 1.5kg
Power supply cord 2m
The standard equipment for the tools shown may differ form country to country
.
This nibbling machine is developed to extend market in metal
industry especially for stainless steel cutting machines.
The main body is double insulated, small and light.
It's designed with lever switch for easy use.
Cycle (Hz)
Minimum cutting
radius(mm)
Hex spaner 3 - 1 piece
Wrench holder 3-7 - 1 piece
CONCEPTION AND MAIN APPLICATIONS
Specifications
Standard equipment
Models No.
Description
New Tool
TECHNICAL INFORMATION

Repair
Disassembling and assembling
1) Changing punch and die
To take off the die, loosen the fastening screw with attached hexagon
socket screw key. Secondary, pull out the punch by turning the screw
counterclockwise with a wrench (13mm). Fasten both the screw and the
locking screw tightly (see the right fig.).
2) Disassembling and assembling spur gear 44 and crankshaft
Take off the gear with arbor press due to press fitting. Press fit from the eccentric processed side of the spur
gear 44 when assembling (see the fig. below).
3) Assembling inside of the gear housing
Assemble the part A, and attach it into inside of the gear housing, ram first. Secondary, attach the part B and fill
grease. Make sure not to drop any washer (see the fig. below).
Punch
Die
Locking screw
Screw
(Eccentric processed part)
Press fitting
Crankshaft Woodruffkey3 Spur gear 44
Rod
Gear housing
Flat washer 8
Ram Flat washer 8 Core washer 6
Part (A)
Part (B)