MecPower Tecway Dining Car User manual

Dining Car

1
In order to prevent the variety of problems which caused by
incorrect operation，Please read the manual first before operating
this machine and pay attention to the items marked in “note”.
Please keep this manual carefully for checking when needed.
Content
Transportation, Installation, Method of transport and Attention
Installation & Operation method
Function adjust method
Maintenance method
Trouble Shooting
Schematic Diagram
Wiring Diagram

2
Safety Attentions
1) Certain part of the game is with high voltage. Adjust the game by
technician. Do not open the game door unless maintenance or parts
replacement is required.
2) Please switch off the power before checking and maintenance.
3) Please switch off the power before opening the game door.
4) Fire extinguisher equipment must be nearby the game.
Installation
The game must be located properly to avoid damages.
Improper Locations:

3
Notes of Usage
1) The voltage range of the game should be 105V~115V or 215V~225V.
The proper voltage should be 110V/220V. The specific voltage accords
to the date plate on the back door of the game. The voltage must be
correct; otherwise it would be difficult to repair the damage.
2) The plug must be plugged in tightly and keep the power cords not be
too tight and damaged in order to prevent bodily injury, short-circuit
and power leakage.
3) To put the machine to normal operating, please properly adjust the
coin match and the game settings when use at the first time.
4) Please regularly check all the functions of the game when operate to
prevent dysfunction.
Notes of Maintenance
1) Be sure to check and maintain the game regularly.
2) Switch off the power before replacing the parts of the game.
3) The parts for replacement should be the same model as the old one.
4) Please check the connection and voltage output after replacing the
power supply.
5) The voltage range of the PCB should be 5.1V-5.4V.
6) Check whether the game has creepage and the voltage before
repairing the PCB.

4
Notes of Clean
1) Please use clean and soft cloth to clean the game.
2) Prevent damaging the surface of the game, please do not use the
following cleanser:
Alterative Cleanser；
Acidic Cleanser；
Insecticide, sterilized water, alcohol or other chemical cleanser.
Notes of Moving and Shipping
1) Properly disassemble the game for necessary moving and shipping.
2) Prevent the game from hitting or being attrite during movement.
3) Protecting the case when move the game.

5
1. Game introduction
Dinning Car with unique, beautiful and comic appearance,
interesting and exciting game, it is specially designed and
developed by our company for the young people. It will be very
essential and popular in amusement center.
Features:
Realistic, colorful;
High-speed processing CPU, stable performances;
Coin selector with high quality fits for various coins.
Simple, strong operational sense and full of entertaining.

6
2. Playing tips and Operations
This game can be played by two players at the same time, and the
roles of two people are different; one player operates at the
steering wheel console, and the other player operates at the screen
console. They can cooperate with each other or play games
individually.
coin selector
Button (A to E)
Steering wheel

7
Playing tips: Insert coin(s), press the lighted button when you are ready, or
wait for countdown.
Steering wheel：When the steering wheel rotates to the left, the light on the
steering wheel turns red; when the steering wheel rotates to the right, the light
on the steering wheel turns blue.
Console：
1）After the game starts, guests will come to order; When the food is ready,
select and press the buttons corresponding to the food they have ordered.
（Notes：press the lighted button）

8
When the guests order more food, the arrows will have different colors to
prompt the players.
2）Mini Games
Make hamburgers: According to the sample, select the ingredients needed by
pressing the buttons.

9
Cut Pizza: Here's how to play

10
Cut the cake: Here's how to play

11
3. Technical parameters
VOLTAGE: AC220V（50/60HZ）
MAX. CURRENT: 0.95A/1.8A
(Note: please refer to the nameplate located on the back of the
games to check actual usage of voltage.)
MAX. POWER: 300W
STANDBY POWER: 100W
COIN SIZE：φ21mm ~ φ30mm (diameter)
φ1.2mm ~φ2.5mm (thickness)
CAPACITY OF COIN BOX: 1,500pcs of coins with coin
sizeφ25mm*1.5mm
LOCATION REQUIRED: -5 ~ 40℃, humidity is less than 90%. No
contact with any corrosive liquid, no any greasiness and dirt.
DIMENSIONS: L1840mm*W1120mm*H1840mm
1120 1840
1650
2020

12
Parts shipped with the game:
NO. DRAWING NAME SPEC./MODEL QTY
1fuse 5A（小） 2
2 key 1285# 2
3key 1396# 2
4power cord 1
5manual 1

13
4. Movement
1) Twist the nut of feet to the bottom, counterclockwise screw the
feet to leave the ground.
2) Unplug the wire
3) Direction of movement diagram:
Note: when the road surface is uneven during moving or when you tilt
the machine, please pay attention to the strength to prevent damage to
the game machine body.
WARNING
Please power off the game first and pull out the cord, then move the game.
Please do not carefully move, turnover, transport the game; otherwise it
will destroy the game.
Prevent hitting, rubbing the games when move the games, otherwise it will
damage the appearance of the game.
wheel
feet

14
5. INSTALLATION
Please follow the direction below to install the game.
5.1 CHOOSE THE LOCATION FOR INSTALLATION
1) Put the Dining Car in the same type of game then select the concrete
placement according to the machine's exterior.
2) Choose the proper location for installation, please follow the below
drawing to install.
NOTE：It must be placed on the flat floor to make the machine on the
ground steadily.
0.5m
0.5m
0.5m
0.5m
1.84m
2.84m
1.12m
2.12m

15
5.2 FIX THE GAME
Screw the feet down to hold the game, distance between ground and wheel is
≥5mm so that the machine can not be moved.
5.3 CHECK AND SET BEFORE CONNECTING THE POWER
1) Please check whether the parts of cabinet are loose caused by moving,
and the wire terminal should not drop out from the port.
2) Check whether the GND is connected.
3) Please check whether the resistance of power input at the both ends for
GND is more than 100 megohm.
4) Adjust the coin selector and check if it can work properly.
5) Connect the wires.
5mm
feet
wheel
Socket
Plug

16
Attention
A. Please make sure the power cord is not pressed by wheel, foundation,
etc. Otherwise, it will damage the wire to cause short circuit, even fire. Do
not use strong power to extend and wring the wires. Do not make the wire
be near to the high temperature object. Properly put the wire to avoid any
kicking or treading.
B. Hold the plug to pull it out from the socket. Do not touch the plug with
wet hands.
AAAA

17
5.4 CHECK AND ADJUST AFTER CONNECTING THE POWER
1) Make sure the input voltage is same as the one stated on name plate
on the back door of the game.
2) After connecting the power, please switch on the game.
3) Insert coin to check if the coin selector cans work properly.
4) Visually check the game and ensure the display monitor and light can
work properly.
5) Enter into the setting program and set the game settings (include coin,
playing time, etc.)
6) Insert coin to play the game, ensure the button and steering wheel is
working properly.
7) Check the sound if it is OK.
6. CHECK BEFORE OPERATION
Check the game before operation to prevent the game from working
improperly when operated.
Checking item：
1) Check if the cord is securely plugged in and without defects.
2) Check the location of game.
3) Check if the game case is without defects or burrs.
4) Check if the game without dirt and properly stuck on with marks

18
7. DAILY OPERATION
7.1 INPUT POWER TO OPERATE
1) Turn on the game machine.
2) Visually check the game and ensure the display monitor is working
properly.
3) Check the light and confirm they are working properly.
4) Check the coin selector, steering wheel, sound and button and confirm
they are working properly.
Note: Only after the above items are confirmed to be normal can the
machine be put into operation.
7.2 COLLECT COINS AND KEEP RECORD
1) Switch off the power and open the coin door to take out the coins
1) 2) Keep a record of the coins’ quantity.

19
8. Game Setting
8.1 Find the buttons
Open the coin door to find the buttons.
Test button（red）：Enter mode selection
Reset button（yellow）：Error reset
Free button（blue）：Free to play
Button B：Up selection
Button C：Confirm
Button D：Down selection
Steering wheel
Coin Selestor
Button (A to E)
Test button
（red）
Reset button（yellow）
Free button（blue）