
7GB/IE/NI
seek the advice of an electrical equipment
specialist.
Only use the product with the supplied mains
adapter 2model A (JT-DC12V2.4W-H2)
model B (JT-DC12V3.6W-H2); all warranty
claims will otherwise expire.
The product is protected against splashes of
water (IP44) as long as the socket meets the
minimum protection standard.
This product is intended for use outdoors but
should be plugged into a socket which is
located in an indoor location (e.g. a shed,
garage or pouch).
The socket into which this product is plugged
must be protected by a residual current circuit
breaker (RCD) with a trip current not greater
than 30 mA.
Sockets positioned outdoors for use with this
product should be of a type which is ade-
quately water proof for an outdoor location
and should be located at least 2.5 m from the
nearest body of water or any location where
water may collect.
Please note that the mains adapter 2will still
use some energy even when the light chain 1
have been switched off if the mains adapter 2
is still plugged in.
To switch the product off completely, unplug
the mains adapter 2from the socket.
The LEDs are non-replaceable.
If the LEDs have reached the end of their lives,
the entire product must be replaced.
Never attempt to install a separate bulb into
a E27 socket.
ATTENTION! The product is
made from glass and is fragile!
Never remove light bulbs and install them in
mains voltage sockets.
Before use
Note: Please remove all packaging material from
the product.
Start-up
Insert the plug of the lead 4into the socket
of the mains adapter 2.
Tighten the union nut 3clockwise.
Plug the mains adapter 2into an easy to
access socket!
Please note that the mains adapter 2will still
use some energy even when the product has
been switched off if the mains adapter 2is
still plugged in. To switch the product off com-
pletely, unplug the mains adapter 2from the
socket.
Timer function
The ON/OFF button
5
has three functions:
1 x push of the button:
The product lights up continuously.
2 x push of the button:
The product lights up continuously for 6 hours
and then switches itself off for 18 hours. The
product will then switch on again for 6 hours
at the allocated time and then switch off for
18 hours.
Note: The ON / OFF button
5
lights up
when
the timer function has been activated.
3 x push of the button:
The product is switched off.
Cleaning and care
CAUTION! DANGER OF ELECTRIC SHOCK!
First pull the mains adapter out of the mains socket.
CAUTION! DANGER OF ELECTRIC SHOCK!
For reasons of electrical safety the mains adapter
2
must never be cleaned with water or other liquids
or immersed in water.
Do not use any solvents, petrol or similar items.
This would damage the product.
Only a dry, lint-free cloth should be used for
cleaning.