MERLYN MB7 User manual

Installation Guide
The wall plugs supplied with the installation kit are for use in solid walls.
Hollow or ‘stud partition’ walls will require alternative fixings. Please consult
a hardware supplier for the correct type. It may also be necessary to consult
your tiling supplier about the correct method for drilling your tiles.

12
11
13
14
15
16
1
2
3
4
5
6
7
8
9
10
parts shown are not to scale
4x40
x3
A2403001
4x12
A2401201
x3
SP0B08070 SP0B08092
SP0B08060L / SP0B08060R
SP0B08062
SP0M7003
SP0M7004
A
A2401201
SP0B08070
A2403001
SP0M7009
N01114 / N01115
SP0M7005
SP0M7007
B
SP0M7006
SP0M7008
SP0M7012
SP0M7005
x1
SP0M7008
x2
SP0M7007
x1
4
N01114
N01115
SP0B08060L
SP0B08060R SP0B08062 SP0M7012

screen
inside
bath edge
3. Insert the screen into the wall profile. Ensure the bottom edge
of the moving panel is parallel to the top surface of the bath.
Fig 3.
4. Drill 3 holes through the wall profile and
fixed panel using a 3.0mm steel drill bit.
Using the screws, fix the screen upright
to the wall profile in 3 places. Fig 4.
6. Fix the top cover cap ( ) to upright profile
and top cover cap(SP0B08060) to wall profile
(SP0M7003). Fig 6.
SP0B08062

8. Fix the cover cap( ) to both hinge. Fig 8. SP0M7012 9. Fix the bottom seal. Fig 9.