Meteor BOLT MINI User manual

INSTALLATION GUIDE
GLARE SHIELD VISOR
meteor-lighting.com
Page 1
• Before wiring to power supply and during servicing or relamping, turn off
power at fuse or circuit breaker.
• All servicing or relamping must be performed by qualified service personnel.
• Product must be grounded to avoid potential electric shock or other potential
hazard.
• Product must be installed at locations and heights, in a manner consistent
with its intended use, and in compliance with Electrical Code and local codes.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
IMPORTANT SAFETY INFORMATION
READ AND FOLLOW ALL SAFETY INSTRUCTIONS

Page 2
INSTALLATION GUIDE
BOLT MINI Glare Shield Visor
Meteor Lighting reserves the right to make changes to this product for design and development improvements at any time without prior notice, and such modification
shall be effective immediately. ©Meteor Illumination Technologies, Inc.
meteor-lighting.com 1300 John Reed Court, Unit B, City of Industry, California 91745 E: [e-mail] T: 213-255-2060
Put the shield on the fixture.
1. Place the tubes in these locations for support.
2. Align the shield to the top of the fixture so the screw holes
line up.
Finish
Tighten the screws in areas where arrows are pointed.
3
21
2
1