Meteor WHIZ 2.0 User manual

meteor-lighting.com
Page 1
• Before wiring to power supply and during servicing or relamping, turn off
power at fuse or circuit breaker.
• All servicing or relamping must be performed by qualified service personnel.
• Product must be grounded to avoid potential electric shock or other potential
hazard.
• Product must be installed at locations and heights, in a manner consistent
with its intended use, and in compliance with Electrical Code and local codes.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
IMPORTANT SAFETY INFORMATION
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
INSTALLATION GUIDE
WIRE GUARD

Page 2
INSTALLATION GUIDE
Meteor Lighting reserves the right to make changes to this product for design and development improvements at any time without prior notice, and such modification
shall be effective immediately. ©Meteor Illumination Technologies, Inc.
meteor-lighting.com 1300 John Reed Court, Unit B, City of Industry, California 91745 E: [e-mail] T: 213-255-2060
3
21
Reattach the bottom cover plate, and then tighten the six
screws on the top of the fixture.
Align the attachment in place and secure it firmly by
tightening the screws.
Remove six screws on the top of the fixture to release the
bottom cover plate.
WHIZ 2.0 WIRE GUARD