Meteor VELA 4 User manual

INSTALLATION GUIDE
meteor-lighting.com
• Before wiring to power supply and during servicing or relamping, turn off
power at fuse or circuit breaker.
• All servicing or relamping must be performed by qualified service personnel.
• Product must be grounded to avoid potential electric shock or other potential
hazard.
• Product must be installed at locations and heights, in a manner consistent
with its intended use, and in compliance with Electrical Code and local codes.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
IMPORTANT SAFETY INFORMATION
READ AND FOLLOW ALL SAFETY INSTRUCTIONS

Page 1
INSTALLATION GUIDE
VELA 4 SHROUD INSTALLATION
Meteor Lighting reserves the right to make changes to this product for design and development improvements at any time without prior notice, and such modification
shall be effective immediately. ©Meteor Illumination Technologies, Inc.
meteor-lighting.com 1300 John Reed Court, Unit B, City of Industry, California 91745 E: [e-mail] T: 213-255-2060
2
1
1
3
Clean the interior and exterior surface using a soft rag
with water.
Fasten Shroud Mounting plate using three phillips screws. Bring shroud to the fixture level and align it to the indicated
openings. Fasten shroud in place with three phillips screws.
*Clean gloves must be worn to avoid dirt and fingerprints
when installing the shroud and diffuser.

Page 2
INSTALLATION GUIDE
Meteor Lighting reserves the right to make changes to this product for design and development improvements at any time without prior notice, and such modification
shall be effective immediately. ©Meteor Illumination Technologies, Inc.
meteor-lighting.com 1300 John Reed Court, Unit B, City of Industry, California 91745 E: [e-mail] T: 213-255-2060
When specifying the conical lens accessory. Cover the
shroud with the conical lens plate and fasten in place using
the provided metal band.
1
Clean the interior and exterior surface using a soft rag
with water.
VELA 4 CONICAL LENS INSTALLATION
2