METER AQUALAB 3 User manual

AQUALAB 3

AQUALAB 3 QUICK START
noitaraperP
Using aWiFi network, connect the Apple®iPad ®mobile digital device
to the network. If the iPad is new, it must be set up and associated
with an Apple ID.
NOTE: The iPad must use a WiFi (not cellular) connection, and the Nexus and the iPad
must be able to communicate with each other on your internal network and with METER
cloud servers.
Install
Follow the steps below to set up the AQUALAB 3. If there is already a
registered Nexus with less than four devices connected, proceed to
Step 3.
Connecting to SKALA Lab
To start collecting data with the AQUALAB3 and SKALA Lab, visit
metergroup.com/aqualab3-training.
18232-00
6.15.2019

3. Connect the AQUALAB 3.
Plug the AQUALAB3 into a power
source and connect to the Nexus
using the USB A to B cable.
that the AQUALAB3 has been
connected to the Nexus.
1. Download and launch the
SKALA mobile app.
To download the SKALA mobile
app to the iPad, use the iPad
camera to scan theQR code
on the back of theNexus. The
application can also be found
by searching for skalamobile by
METER in the Apple App Store.
In the SKALA mobile app, create
a company account, main
administrative username, and
password.
2. Register Nexus and
connect to power.
Select the plus symbol and scan
theQR code on the bottom of
the Nexus. Repeat this for each
Nexus purchased.
Connect the Nexus to power and
ethernet. The Nexus MAC address
can be found on the bottom of the
device.
NOTE: The iPad must use a WiFi (not
cellular) connection, and the Nexus and
the iPad must be able to communicate
with each other on your internal network
and with METER cloud servers.
Installation
4. Enter products and
specications.
The AQUALAB 3is now ready.
For more information on the
AQUALAB 3 including training
videos and information, visit
metergroup.com /aqualab3-
training .

Complete Moisture Analysis
FOUR MARKS, ALTON, HAMPSHIRE GU34 5PZ
TEL: ++44 (0)1420 568150 FAX: ++44 (0)1420 568151
[email protected] www.labcell.com
LABCELL LTD
Version 1.0 July 2019