Metra Electronics 99-7414 User manual

Disconnect the negative battery terminal to prevent an accidental short circuit. Open the
storage compartment, pull out on the lip of the compartment opening and remove the storage
compartment/trim bezel assembly. Grasp the back of the pocket trim bezel, pull out on the
bezel and remove. Remove (4) screws securing the sub-dash bracket assembly and remove
the assembly. Remove (2) screws securing the bottom of the climate control trim bezel and
(4) screws securing the head unit to the sub-dash bracket assembly. Unsnap the climate
control trim bezel from the head unit and head unit trim bezel.
Slide the aftermarket head unit into the sub-dash
bracket assembly and mount the head unit with
(4) screws supplied with the head unit.
Locate the (4) mounting positions for the sub-dash
bracket assembly ("A").
1
2
5
12
ALL VEHICLES
6
4
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
Mount the sub-dash bracket assembly to the sub-dash with (4) screws previously removed in
step #1. Mount the Radio Housing/climate control trim bezel assembly over the mounted sub-
dash bracket assembly with (2) screws previously removed in step #1.
Snap the tabs on the top of the climate
control trim bezel into the slots on the
bottom of the Radio Housing.
3
"A"

99-7414
INSTALLATION
INSTRUCTIONS
APPLICATIONS
CAR PAGE
NISSAN
Sentra 2000-02...........................................................1-2
KIT COMPONENTS
TOOLS REQUIRED
Phillips screwdriver
Radio Housing
KIT FEATURES
ISO-DIN
head unit
provisions
Factory pocket
retention
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION
Rev.201202