Metra Electronics 99-9303 User manual

INSTALLATION INSTRUCTIONS FOR PART 99-9303
Small Flat Blade Screwdriver • Phillips Screwdriver
1-800-221-0932 www.metraonline.com
KIT FEATURES
REV. 04-17-09 © COPYRIGHT 2004-2009 METRA ELECTRONICS CORPORATION
BMW Z4
2003-2008
•DIN Head Unit Provision
A) Radio Housing
KIT COMPONENTS
TOOLS REQUIRED:
99-9303
A
TABLE OF CONTENTS
Dash Disassembly: pg. 1
Kit Assembly: pg. 2
Final Assembly: pg. 3
WIRING AND ANTENNA CONNECTIONS
(Sold Separately)
•40-EU10 - European antenna adapter
•70-9003 - European harness
APPLICATIONS

99-9303
DASH DISASSEMBLY
Disconnect the negative battery
terminal to prevent an accidental
short circuit.
NOTE: Makesure the vent on/off dials
are in the middle position.
1
Using a small flat blade screwdriver,
release the metal clip located inside
the vents facing upward on the left
and right side while pulling the vents
outwardfrom the dash.
(Figure A)
2
A
BMW Z4 2003-2008
B
Remove (2) Phillips screws exposed
at top of radio and remove. (Figure B)
3
1

99-9303
2
KIT ASSEMBLY
DIN HEAD UNIT PROVISION
1
Screw the 99-9303 housing into the
dash opening instead of the factory
radio.
(Figure B)
2
Slide the DIN cage into the space in
the 99-9303 and secure by bending
the metal locking tabs outward.
(Figure C)
3
Slide the aftermarket head unit into
the DIN cage until secure.
(Figure D)
B
CD
A
NOTE:
The bottom bar connecting the two sides
of the 99-9303 will need to be cut and
removed prior to Kit Assembly.
(Figure A)

3
99-9303
FINAL ASSEMBLY
A
Locate the factorywiring harness in the
dash. Metra recommends using the proper
mating adapter and making the connections
as shown. (Isolate and individually tape off
the ends of any unused wires to prevent
electrical short circuit)
Re-connect the negative battery terminal and test
the unit for proper operation.
A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D) Tape
1
2
Reassemble radio and dash assemblies in
reverse order of disassembly.
3
B
C
D
K NOWLEDGE IS P OWER
Enhanceyour installation and fabrication skillsby
enrolling in the most recognizedandrespected
mobile electronics school in our industry.
Log onto www.installerinstitute.comor call
800-354-6782 for more informationandtake steps
toward abetter tomorrow.