Middle Atlantic Products C5 SERIES CREDENZA RACK User manual

I-00689 Rev B
C5 SERIES
Flip-Up Side Shelf
instruction sheet
Thank you for purchasing the C5 Series Flip-Up Side Shelf. Please read these instructions
thoroughly before installing this product.
THANK YOU
• Weight rated to 35 lbs. of maximum capacity.
PRODUCT FEATURES

IMPORTANT SAFETY INSTRUCTIONS / INSTRUCTIONS IMPORTAANTES SUR LA SÉCURITÉ
Page 2
WARNING! Failure to read, understand and follow the
following information can result in serious personal injury,
damage to the equipment or voiding of the warranty. It is
the responsibility of the Installer/User to ensure
that this product is loaded according to specifications.
AVERTISSEMENT! Refus de lire, comprendre et suivre
la renseignements suivants peut traduire par de graves
blessures, des dommages à l'équipement ou invalider la
garantie. Il est la responsabilité de l'installateur / utilisateur
de s'assurer que ce produit est chargé conformément aux
spécifications.
!
!
!
WARNING! Middle Atlantic Products, Inc. electrical
systems conform to and should be properly grounded in
compliance with requirements of the current National
Electrical Code or codes administered by local
authorities.
All electrical products may present a possible shock or fire
hazard if improperly installed or used. Middle Atlantic
Products, Inc. electrical products may bear the mark of a
Nationally Recognized Testing Laboratory (NRTL) and
should be installed in conformance with current local and/or
the National Electrical Code.
!
AVERTISSEMENT! Middle Atlantic Products, Inc.
électrique systèmes conformes à devraient être mis à la
terre dans conformité avec les exigences de la National
actuelle ou comme les codes électrique administré par les
autorités locales autorités.
Tous les produits électriques peuvent présenter un choc ou
un incendie danger si elle est mal installé ou utilisé. Middle
Atlantic Products, Inc. produits électriques peuvent porter
la marque d'un Nationally Recognized Testing Laboratory
(NRTL) et doit être installé en conformité avec courant local
et/ou le National Electrical Code.
10-32 x 1 3/4 Phil. Pan Zinc Screws (6x)
10 x 3/4 Phil. Pan Wood Screws (10x)
10-32 x 3/4 Phil. Pan Zinc Screws (6x)
Flip-Up
Shelf
Mounting
Brackets
(2x)
10-32 x 7/16 Zinc T-Nuts (6x)
SUPPLIED COMPONENTS AND HARDWARE
!
WARNING! Do not exceed the 35 lb maximum load rating.
Use with heavier loads may result in instability causing tip
over resulting in death or serious injury.
!
AVERTISSEMENT! Ne pas dépasser la £ 35 capacité de
charge maximale. Utiliser avec des charges plus lourdes
peuvent provoquer une instabilité pointe plus entraînant la
mort ou des blessures graves.

Page 3
REQUIRED TOOLS
• #2 Phillips Screwdriver (at least 6” long)
• Drill
INSTALLATION
NOTE: Installation of the brackets must be done with the C5 top off.
1. Remove the side panel on the side you wish to install the shelf.
2. Prepare your side panel based on the following C5 models:
• For Thermolaminate and HPL C5 models,
englarge pre-drilled mounting holes from
the inside of the side panel using a 1/4”
drill bit (FIGURE A).
• All other models already have pre-drilled mounting
holes.
3. Hammer T-nuts into each of the holes from
the inside of the side panel. (FIGURE A)
4. Install shelf brackets using the following screws based on your C5 model:
FIGURE A
NOTE: On Klasik C5 models, one less T-nut
and screw is used because there is no hole in
the location closest to the front hinge plate.
T-Nuts
(6)
Mounting
Holes
(6)
• On Sota and Klasik C5 models, use
10-32 x 3/4” screws. (FIGURE B)
• On Moderno C5 models, use
10-32 x 1 3/4” screws.
Use 3 screws per bracket and leave them loose
for any necessary adjustments.
• 1/4” Drill Bit
• Hammer
FIGURE B
NOTE: On Klasik C5 models, one less T-nut
and screw is used because there is no hole in
the location closest to the front hinge plate.

INSTALLATION (CONTINUED)
Page 4
FIGURE C
PLASTIC TUBE
5. Remove the plastic tube from both brackets. (FIGURE C)
FIGURE D
NOTE: Ensure the brackets are in the full open position prior to installing the shelf.
6. Place the shelf on the brackets. Install shelf using using (8) 10 x 3/4” Phillips pan head wood screws,
4 places per bracket. Leave the screws loose for any necessary adjustments. (FIGURE D)
7. Install the C5 top. Ensure the top is properly aligned
with the shelf prior to screwing it down to the frame.
8. Once the shelf and the top are aligned properly, tighten the previously installed screws. DO NOT
OVERTIGHTEN.
NOTE: Additional holes are provided to install the shelf on either side of the credenza.

Page 5
WARRANTY
Middle Atlantic Products, Inc. (the "Company") warrants the product to be free from defects in material or
workmanship under normal use and conditions for a period of (3) three years from the date of shipment by
the Company.
The Company's entire liability to the purchaser, and the purchaser's (or any other party's) sole and
exclusive remedy, under this warranty shall be limited, at the Company's option, to either (a) return of and
refund of the price paid for, or (b) repair or replacement at the Company's factory of the products
purchased, or any part or parts thereof, which the Company has determined to be defective after
inspection thereof at the Company's factory. This warranty does not cover damage due to acts of God,
accident, misuse, abuse or negligence by parties other than the Company, or any modification or
alteration of the products. In addition, this warranty does not cover damage due to improper handling,
assembly, installation or maintenance.
THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES OF ANY KIND, EITHER EXPRESSED OR
IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE.
TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, IN NO EVENT SHALL THE
COMPANY BE LIABLE FOR ANY SPECIAL, INCIDENTAL, INDIRECT, OR CONSEQUENTIAL
DAMAGES WHATSOEVER (INCLUDING, WITHOUT LIMITATION, DAMAGES FOR LOSS OF
BUSINESS PROFITS, BUSINESS INTERRUPTION OR ANY OTHER PECUNIARY LOSS) ARISING
OUT OF THE USE OF THE PRODUCTS PURCHASED, EVEN IF THE COMPANY HAS BEEN ADVISED
OF THE POSSIBILITY OF SUCH DAMAGES. THE COMPANY'S LIABILITY TO THE PURCHASER (OR
ANY OTHER PARTY) HEREUNDER, IF ANY, SHALL IN NO EVENT EXCEED THE PURCHASE PRICE
OF THE PRODUCTS PAID TO THE COMPANY.
Corporate Headquarters
Corporate Voice 973-839-1011 - Fax [phone] / International Voice [phone]
Fax [phone]
middleatlantic.com - [email protected]
Middle Atlantic Canada
Voice 613-836-2501 - Fax [phone] / middleatlantic.ca - [email protected]
Factory Distribution
USA: NJ - CA - IL Canada: ON - BC
At Middle Atlantic Products we are always listening. Your comments are welcome.
Middle Atlantic Products is an ISO 9001 and ISO 14001 Registered Company.