Miles Industries 700I User manual

Ceramic Rocks Installation
For ceramic logs, see previous section. Unpack the ceramic rocks very carefully to avoid damaging them. Install
the rocks as shown.
Please note that the position of some of the rocks identified in the following instructions is critical to ensure
proper performance of the appliance.
Note: The rocks 17 and 18, as well as the twigs may be installed or omitted at the customer’s choice.
1. Install the platform into the firebox on top of the
burner. The metal tabs at the bottom of the platform
slide into the slots in front of the burner.
2.
3. Insert the ceramic rock base in the platform behind
the burner. Ensure that the base lies against the
metal tabs behind the burner.
4. Each rock is embossed underneath with a number
and an arrow indicating its position. The arrow
points to the front of the fireplace when the rock
is installed. See the image at the beginning of this
section to help you identify and position the rocks.
Metal tab
12 3 5
6
7
8
9
10
11
12
13
14
15
17
16
18
4
31
QUALIFIED
INSTALLER
Model 700I

14 11 97
5. Identify rocks number 1, 2, 3, 4 and 5. These rocks
have pegs that fit in the holes on top of the rock
base. Install these rocks positioning them so the
arrow embossed underneath points to the front of
the fireplace.
6. Identify rocks number 15 and 16 and place them on
the rock base, on each side of the back row.
7. Identify rocks 6, 8, 10, 12 and 13. These rocks
have two holes that fit on the pegs of the ceramic
platform. Install these rocks positioning them so the
arrow embossed underneath points to the front of
the fireplace.
14 11 97
17 18
13 6
8
10
8. Identify the rocks 7, 9, 11 and 14. These rocks
have one hole underneath and fit on the peg of
the rocks 6, 8, 10 and 13 respectively. Install these
rocks positioning them so that the arrow embossed
underneath points to the front of the fireplace.
Rock combinations:
7 on top of 6
9 on top of 8
11 on top of 10
14 on top of 13
The rock 12 remains on its own.
9. Slightly rotate rocks 7 and 11 forward so they rest
on the rocks to their left.
Slightly rotate rock 14 forward so it rests on the rock
to its right.
10. Optional: Install the rocks 17 and 18 on the
platform. They can be placed on each side of the
rock pile as suggested or elsewhere on the platform.
123
45
13
15
12 10
16
86
Ceramic Rocks Installation
32
QUALIFIED
INSTALLER

Burner rail
Pilot
These rocks overhang slightly above the
burner but do not touch the black base
IMPORTANT: The rocks of the top row (14, 11, 9
and 7) overhang slightly over the burner.
11.Optional: Lay the twigs on the rocks. They can be
placed as suggested below or elsewhere on the
rocks as long as they do not block the pilot flame or
the burner flame.
12. Optional: As well, you can add the front bricks if
desired, sliding them under the platform front edge.
Ceramic Rocks Installation
Side Shrouds Installation
The side shrouds are required to install the front on
the appliance. They are supplied with the engine.
Fit them to the appliance outer case as indicated
(2 screws/side).
See instructions supplied with the front trim for
installation of trim.
Door hinge tabs
should face
inwards
33
QUALIFIED
INSTALLER