Mocka Brooklyn User manual

Phillips & Flathead screwdrivers required
E F
bolt
x2
6
nut
x2
For quicker assembly, we recommend the
use of a power drill on a low-speed setting.
Brooklyn Single Bed
1
mocka.co.nz | mocka.com.au
Assembly Instructions
Thank you for your purchase.
Please follow the instructions below for correct assembly.

1
E
E
F
FC
C
To begin assembly of the Brooklyn Single Bed, insert 2x dowels (C) into panel [5] and attach
each end to panels [1] using 2x bolts (E) and secure with 2x nuts (F). Tighten with a screwdriver.
Now insert 4x dowels (C) into the ends of panels [1].
5
Brooklyn Single Bed
2
mocka.co.nz | mocka.com.au
Assembly Instructions

1
E
E
F
FC
C
To begin assembly of the Brooklyn Single Bed, insert 2x dowels (C) into panel [5] and attach
each end to panels [1] using 2x bolts (E) and secure with 2x nuts (F). Tighten with a screwdriver.
Now insert 4x dowels (C) into the ends of panels [1].
5
2
Brooklyn Single Bed
3
mocka.co.nz | mocka.com.au
Assembly Instructions

3
4
Unroll the base slats [4] and place into position on the inner
support of the side panels. Ensure the slats align in place with
the pre-drilled holes in either end of the supports and the
strapping is facing upwards.
Attach the base slats to the supports using 2x screws (D) in
each corner as shown. Tighten securely with a screwdriver.
Once assembled lift into place, do not drag. You’re done,
enjoy!
Brooklyn Single Bed
Assembly Instructions
4
mocka.co.nz | mocka.com.au