Mocka Emmett Bed User manual

40
Emmett Bed
Assembly Instructions

Attach legs 4x (3) to panels (1) and (2) as shown. Attach two panels (4) to panel (1) with 2 (J) plates as shown. Repeat
this step by attached two panels (4) to panel (2) using the (J) plates.
1
4
4
4
4
2
12
Emmett Bed
Assembly Instructions

Attach all panels (4) together with 2x connectors (B) as shown. Attach 2x metal bracing (6) to the bed frame with 4x the 25mm bolt (D)
and tighten with the large allen key (K) as shown.
NOTE: only tighten the bolts for the bracing bars and legs (7) halfway
to allow for some movement while assembling. Then tighten all bolts at
then end.
1
4
4
4
4
2
34
Emmett Bed
Assembly Instructions

Attach 1 x centre bracing bar (5) to the connectors. Attach 2x support
legs 2 x (7) to this bar as shown.
Lay the 2 x bracing bars (8) and (9) across the frame as shown. Attach
to panels (1) and (2) with bolts ( C ), tighten with allen key (K).
Connect the 2 x bars (8) and (9) and the support leg (7) together in the
centre and secure with bolt (H) as shown. Attach he other 2 x legs (H)
to frame as shown.
NOTE: only tighten the bolts for the bracing bars and legs (7) halfway
to allow for some movement while assembling. Then tighten all bolts at
then end.
56
Emmett Bed
Assembly Instructions
1
2

78
Emmett Bed
5
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558
Make sure all of the bolts have now been tightened up for all the legs
and bracing bars.
Insert wooden slats (10) into the sides one on each side and join them
in the middle by sliding into the double cap (A) then push down to click
into place. Repeat this from top of bed to the base.
Lift bed into position without dragging.
You're done, enjoy!