Mocka Orlando User manual

mocka.co.nz I mocka.com.au I PO BOX 18, Pinkenba QLD 4008
ASSEMBLY I N S TRUCTION S
Orlando
Contemporary Cot
Thank you for purchasing a Mocka Orlando Contemporary Cot.
Please follow the manufacturer’s assembly instructions in detail
to ensure the safety features of the cot are not compromised.
A
HARDWARE SUPPLIED
4x
B
bolt
8x
C
bolt
4x
D
bolt
1 x
allen key
WARNING: TO PREVENT FALLS, THE MATTRESS BASE OF THIS COT
SHOULD BE ADJUSTED TO THE LOWEST POSITION BEFORE THE
CHILD CAN SIT UP
Ensure the cot is placed at a reasonable distance from curtains, blinds, heaters
and power points. Keep all medications, string, elastic, small toys or small items,
such as money, out of reach from any position in the cot.
Assembly
Care must be taken when attaching sides. Do not over-tighten screws as this can
cause damage to the cot.
Care and Maintenance
Regularly check all screws for tightness or damage that could render the cot
unsafe. To clean, use a damp cloth, avoiding the use of detergents or abrasives.
Recommended mattress size
This cot has been manufactured for use with a mattress which measures 1300mm
because it is important that gaps between the mattress and the sides and ends
of the cot will not exceed 40mm when the mattress is pushed to one side or end,
and 20mm when the mattress is centred in the cot. This is to minimize the risk
of a child’s limb becoming caught in the gap. The thickness of the mattress has
the mattress base in the lower position to minimize the risk of a child climbing or
falling out of the cot.

1 2
Attach panel [1] to 1 x panel [2] with 2 x bolts (A).
Tighten all bolts with alien key (D).
Attach 2 x panels [3] to panel [2] with 4 x bolts (B).
Lock 2 x bolts (C) into panel [2]. Tighten all bolts with alien key (D).
mocka.co.nz I mocka.com.au I PO BOX 18, Pinkenba QLD 4008
ASSEMBLY I N S TRUCTION S
Orlando
Contemporary Cot

mocka.co.nz I mocka.com.au I PO BOX 18, Pinkenba QLD 4008
ASSEMBLY I N S TRUCTION S
Orlando
Contemporary Cot
34
Attach panel [1] to 1 x panel [2] with 2 x bolts (A).
Tighten all bolts with alien key (D).
Attach 2 x panels [3] to panel [2] with 4 x bolts (B).
Lock 2 x bolts (C) into panel [2]. Tighten all bolts with alien key (D).

mocka.co.nz I mocka.com.au I PO BOX 18, Pinkenba QLD 4008
ASSEMBLY I N S TRUCTION S
Orlando
Contemporary Cot
56
OPTIONAL: To adjust mattress base setting, push the bolts (C) out from the
alternative holes with alien key (D). and repeat steps 1 and 3 by removing the
side panel and moving the base to corresponding holes. Securely attach again
in the adjusted position.