Mocka Vancouver Cot User manual

Hardware Supplied
Side Panel
Cot Mattress Base
End Panel
Ensure the cot is placed at a reasonable distance from curtains, blinds, heaters and
power points. Keep all medications, string, elastic, small toys or small items, such as
money, out of reach from any position in the cot.
Assembly
Care must be taken when attaching sides. Do not over-tighten screws as this can cause
damage to the cot.
Care and Maintenance
Regularly check all screws for tightness or damage that could render the cot
unsafe. To clean - use a damp cloth, avoiding the use of detergents or abrasives.
Recommended mattress size
This cot has been manufactured for use with a mattress which measures 1300mm long x
mm wide x 100mm in thickness. The width and length are specified because it is
important that gaps between the mattress and the sides and ends of the cot will not
exceed 40mm
This is to minimize the risk of a child’s limb becoming
caught in the gap. The thickness of the mattress has been specified to ensure that the
depth of the cot is greater than 500mm with the mattress base in the lower position to
minimize the risk of a child climbing or falling out of the cot.
WARNING: TO PREVENT FALLS, THE MATTRESS BASE
OF THIS COT SHOULD BE ADJUSTED TO THE LOWEST
POSITION BEFORE THE CHILD CAN SIT UP
x12
B
A
x4
CD
x12
x1
screw long screw
bolt nut
Allen key
E
x4
small screw
1
mocka.co.nz | mocka.com.au | PO Box 6171, Maroochydore, BC, 4558, QLD.
Assembly Instructions
Thank you for your purchase.
Please follow the manufacturers assembly instructions
in detail to ensure the safety features of the cot are not
comprised.
Vancouver Cot

12
Vancouver Cot
2
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558
Attach 2 x side panels to base and secure with 4 x screws (A). Tighten
with an allen key (D).
Attach 2 x end panels to assembled frame as shown and secure with
12 x screws (B). Tighten with an allen key (D).

3
Vancouver Cot
3
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558
OPTIONAL: To adjust mattress base setting, repeat steps 2 and 3 by
removing the side panel, unscrewing screws (A), (B) & (E), and move the base
to the corresponding holes. Securely fasten again in the adjusted position and
replace the screws, using the spare holes you took the base from.