Nerf BLASTER SCOOTER 2.0 User manual

NERF BLASTER
SCOOTER 2.0
We at Flybar, Inc. value the safety of all of our children and recommend
the use of an approved safety helmet when using this toy.
ITEM # NF33130B
8+
Max Weight:
185 Lbs
TO AVOID EYE INJURY:
WARNING: Do not aim
at eyes or face. Use of eyewear recommended
for players and people within range. Use only
ocial NERF darts. Other darts may not meet
safety standards. Do not modify darts or blaster.
POUR ÉVITER TOUTE BLESSURE AUXYEUX :
ATTENTION : Ne pas viser les
yeux ni le visage. Le port de lunettes est recommandé
pour les joueurs et les gens à portée de tir. N’utiliser que
les fléchettes NERF ocielles. Les autres fléchettes
pourraient ne pas répondre aux normes de sécurité. Ne
pas modifier les fléchettes ni le blaster.
OWNER’S MANUAL
1.5V
AA / LR6
Not included.
x4
Nerf_blaster_scooter_2_manual.indd 1Nerf_blaster_scooter_2_manual.indd 1 5/9/22 11:48 AM5/9/22 11:48 AM

ATTENTION:
1. Before you allow your child to use Nerf Blaster Scooter, ensure that the steering
rod is fully engaged and that all the screws are tight. Also ensure that the wheels have
been correctly secured and that they show no signs of wear.
2. Warning: Protective equipment should be worn. Ensure that your child always
wears a helmet, wrist, elbow and knee pads, as well as shoes with rubber soles.
3. Ensure that your child does not ride down any steep hills. The brake is not designed
to decelerate from high downhill speeds.
4. The brake pad becomes hot when it is used. Make especially sure that your child
does not keep the brake on for a long period of time. Explain to your child that direct
skin contact may cause burns.
5. Do not allow your child to travel at speeds exceeding 6 mph.
6. Ensure that your child does not ride on roads, paths or other places with motor
vehicle trac.
7. Only one child may ride on the Nerf Blaster Scooter at any one time.
8. Never allow your child to ride the Nerf Blaster Scooter at dusk or at night.
9. The Nerf Blaster Scooter must not be used on wet, oily, sandy, dirty, icy, rough or
uneven surfaces.
10. Parental or adult suspension is strongly recommended.
11. Do not make any modications to the Nerf Blaster Scooter.
12. Suitable for children up to approx 150cm.
13. Important: Undoing the axle screws several times will reduce the eect of the
screw securing products. This means that the screws may come loose by themselves.
You should therefore always use a conventional screw securing product.
14. Some metal parts may corrode after a certain time, especially when used near the
sea or left outdoors too often.
15. Warning! The toy needs to be used with caution, since skill is required to avoid falls
or collisions causing injury to the user or third parties.
16. User age and maximum loading weight. 185 lbs. (38kg) max and 8+ years
17. Avoid sharp bumps, drainage grates, and sudden surface changes.
Scooter may suddenly stop.
18. Adults must assist children in the initial adjustment procedures to unfold scooter,
adjust handlebar and steering to height, and nally to fold scooter.
19. Obey all local trac and scooter riding laws and regulations.
20. Watch out for pedestrians.
Nerf_blaster_scooter_2_manual.indd 2Nerf_blaster_scooter_2_manual.indd 2 5/9/22 11:48 AM5/9/22 11:48 AM

6
3
2
4
7
9
10
8
5
1
PARTS AND FEATURES
1. Deck
2. Wheels
3. Brake
4. Stem
5. Deck release clamp
6. Clip
7. Blaster
8. Stem clamp
9. Hand grip
10. Kick-stand
11. Darts
11
Assembly required
Nerf_blaster_scooter_2_manual.indd 3Nerf_blaster_scooter_2_manual.indd 3 5/9/22 11:48 AM5/9/22 11:48 AM

ASSEMBLY
NERF BLASTER SCOOTER 2.0 ASSEMBLY
1
2 3
Release deck clamp and push up on deck lever
to lock stem into vertical position. Once locked
into position tighten deck clamp.
Insert blaster and stem into down stem of
scooter. Slide stem clamp down over seam
where two stems meet and tighten into
place using the screw driver provided.
Slide hand grip over shaft and snap into
place using lock button.
Deck
clamp
Down
stem
Folded position
Deck
Lever
Hand
grip
4
5
Use blaster angle release button to adjust blaster
angle to 90º or desired liking for riding or blasting.
For fast riding and storing it is recommended that
blaster be in the closed 0° position.
Insert clip into bottom of blaster. Make
sure to insert in correct direction as
instructed on clip.
6Complete assembly.
Blaster angle
release button
Stem
clamp
Clip
Nerf_blaster_scooter_2_manual.indd 4Nerf_blaster_scooter_2_manual.indd 4 5/9/22 11:48 AM5/9/22 11:48 AM

BATTERY ASSEMBLY
2
1.5V
AA / LR6
Not included.
x4
1Locate blaster battery cover on right
side of blaster with screw closure.
Use supplied screw driver to unscrew
and remove battery cover from
blaster.
Use qty 4 (1.5V AA/LR6) batteries to ll
battery compartment. Make sure to follow
battery insertion direction marked in
compartment. Once batteries are installed
properly screw battery cover back on and
secure to blaster.
IMPORTANT BATTERY INFORMATION
WARNING: 1. TO AVOID BATTERY LEAKAGE A. Always follow the instructions
carefully. Use only batteries specied and be sure to insert them correctly by match-
ing the + and – polarity markings. B. Do not mix old batteries and new batteries or
standard (carbon-zinc) with alkaline batteries. C. Remove exhausted or dead batteries
from the product. D. Remove batteries if product is not to be played with for a long
time. E. Do not short-circuit the supply terminals. F. RECHARGEABLE BATTERIES: Do not
mix these with any other types of batteries. Always remove from the product before
recharging. Recharge batteries under adult supervision. DO NOT RECHARGE OTHER
TYPES OF BATTERIES.
2. Should this product cause, or be aected by, local electrical interference, move
it away from other electrical equipment. Reset (switching o and back on again or
removing and re-inserting batteries) if necessary.
Nerf_blaster_scooter_2_manual.indd 5Nerf_blaster_scooter_2_manual.indd 5 5/9/22 11:48 AM5/9/22 11:48 AM

HOW TO ADJUST THE HEIGHT
Use the stem clamp and the
quick release snap buttons
on stem to adjust riding
height.
37”
35” 33”
3 RIDING HEIGHTS
Stem
clamp
Stem
snap
buttons
CLEARING JAMS
STORING YOUR BLASTER
CHECK BARREL AREA FOR A JAMMED DART.
•Open the jam clearing door and remove any
jammed darts.
•Close jam clearing door.
NOTE: Blaster will not function unless jam
clearing door is fully closed.
NOTE: Do not store blaster ready to re. Be sure to unload DARTS from blaster
before putting it away. Remove batteries if storing Blaster Scooter for an extended
period of time. For storing it is recommend that blaster be in the closed, 180
degree position.
Nerf_blaster_scooter_2_manual.indd 6Nerf_blaster_scooter_2_manual.indd 6 5/9/22 11:48 AM5/9/22 11:48 AM

BLASTER USE
FIRING
LOADING AMMO
TO AVOID EYE INJURY:
WARNING: Do not aim
at eyes or face. Use of eyewear recommended
for players and people within range. Use only
ocial NERF darts. Other darts may not meet
safety standards. Do not modify darts or blaster.
POUR ÉVITER TOUTE BLESSURE AUXYEUX :
ATTENTION : Ne pas viser les
yeux ni le visage. Le port de lunettes est recommandé
pour les joueurs et les gens à portée de tir. N’utiliser que
les fléchettes NERF ocielles. Les autres fléchettes
pourraient ne pas répondre aux normes de sécurité. Ne
pas modifier les fléchettes ni le blaster.
• Do not aim at eyes or face. TO AVOID INJURY: Use only darts designed for this
product. Do not modify darts or dart blaster.
• Be sure to read and follow all instructions carefully before using this product.
• NOTE: Jam clearing door must be fully closed for blaster to re.
TRIGGER BUTTON
Press and hold trigger button till you here
motors engage and dart blasts - then release.
If you keep trigger button pressed – darts will
blast in rapid re mode very quickly.
LOAD DARTS INTO THE QUICK RELOAD CLIPS.
•Be sure darts are inserted in direction
indicated on clip.
•Insert 1 dart at a time and push down.
•Clip can hold up to 6 darts. Do not insert more
than 6 darts.
• Insert clip into main blaster unit (make sure
arrow on clip points away from trigger).
• Press clip release buttons and remove
clip to store or reload.
Nerf_blaster_scooter_2_manual.indd 7Nerf_blaster_scooter_2_manual.indd 7 5/9/22 11:48 AM5/9/22 11:48 AM

MAINTENANCE AND CHECK BEFORE RIDING
• Check that all parts are suciently tightened, and the handlebar is securely xed.
• Check that all wheels can be spun smoothly and that the footplate is securely
fastened.
• All nuts and bolts may lose their tightness over time, please check the tightness
of all nuts and bolts every time you ride.
• The wheels may become worn out with natural wear and tear over time. Please check
the condition of the wheels regularly and replace them when necessary. Please contact
Manufacturer – Flybar, Inc. for replacements.
• Do not use a wet cloth, alcohol, industrial cleaners or solvents to clean the scooter as
this may result in loss of gloss, the removal of decals or dissolve the materials in the
scooter.
• Do not use attachments not included with the scooter. Do not attempt to make any
modications to the scooter by yourself.
Nerf_blaster_scooter_2_manual.indd 8Nerf_blaster_scooter_2_manual.indd 8 5/9/22 11:48 AM5/9/22 11:48 AM

One Year Limited Warranty on Nerf Blaster Ride-on product
Flybar, Inc. warrants this product to the original retail purchaser as follows: The ride-on
product is warranted against defective materials or workmanship for one year from
the date of original purchase. An original receipt is required to validate your warranty.
Flybar, Inc. will, at its option, provide replacement parts or replace this product. Flybar,
Inc. reserves the right to substitute if the part or model has been discontinued. To
make a claim under this warranty you must contact us directly. Proof of purchase is
required, and shipping/transportation charges are the responsibility of the consumer.
What does this Limited Warranty cover?
This Warranty covers all parts of the Nerf Blaster ride-on toy to be free from defects
in workmanship and materials. This Warranty is only eective if:
• The ride-on toy is used under normal conditions for its intended purposes, by a
person that properly ts and is capable of controlling the ride-on.
• The ride-on toy receives all necessary maintenance and adjustments.
What is not covered by this Limited Warranty?
This Warranty does not include labor and transportation charges. You, the original
purchaser will be responsible for labor or transportation charges associated with
the repair or replacement of any parts found to be eligible for warranty coverage.
This Warranty does not cover any damage caused by crash, collision, misuse, abuse,
neglect, improper assembly, improper maintenance, lack of maintenance, alteration,
or any similar damage to the ride-on toy. For personal use only. Not for
commercial use.
This Warranty will be void if the ride-on product is ever:
• Installed with a motor or modied in any other way.
• Used in a manner contrary to the instructions in the manual included
with this product.
• Flybar, Inc. will not be liable for incidental or consequential loss or damage,
due directly or indirectly from use of this product.
How do you make a claim under this Limited Warranty?
Warranty claims should be submitted via Flybar’s online portal at www.ybar.com/
pages/contact-us or via email at info@ybar.com. Please have your proof of purchase
available before calling to validate your claim.
Limitation of Damages:
The warranty and remedies as set forth are exclusive and in lieu of all others, oral or
written, expressed or implied. In no event will Flybar, Inc. or the dealer selling this
product be liable to you for any damages, including incidental or consequential
damages, arising out of the use or inability to use this product. Some states do not
allow limitations as the exclusion or limitation of incidental or consequential damages,
so the above limitation may not apply to you.
WARRANTY
Nerf_blaster_scooter_2_manual.indd 9Nerf_blaster_scooter_2_manual.indd 9 5/9/22 11:48 AM5/9/22 11:48 AM

Nerf_blaster_scooter_2_manual.indd 10Nerf_blaster_scooter_2_manual.indd 10 5/9/22 11:48 AM5/9/22 11:48 AM