Nerf BLASTER SCOOTER User manual

BLASTER SCOOTER
3 WHEEL TILT&TURN SCOOTER MODEL NO.: M5
OWNER’S MANUAL
DO NOT AIM AT EYES OR FACE.
TO AVOID INJURY: USE ONLY
DARTS DESIGNED FOR THIS
PRODUCT. DO NOT MODIFY
DARTS OR DART BLASTER.
BE SAFE, ALWAYS WEAR A
HELMET AND OTHER PROTEC
TIVE GEAR.
CAUTION!
X6 C
BATTERIES
NOT INCLUDED
6+
AGE
ANS
EDAD
SHOCK ABSORBING
RUBBER GRIPS
STANDARD NERF
CLIP
EASY STEP
BRAKE
STEEL FRAME
TEXTURED MOLDED
SURFACE DECK
DUAL BARREL
BLASTER
2 HEIGHT
ADJUST-ABILITY
LARGE EASY
STEERING WHEELS
FIRES UP TO
TIRE JUSQU'À 12 MÈTRES
DISPARA HASTA 12 METROS
FEET!!
40
FIRES UP TO
TIRE JUSQU'À 12 MÈTRES
DISPARA HASTA 12 METROS
FEET!!
40
FIRES UP TO
TIRE JUSQU'À 12 MÈTRES
DISPARA HASTA 12 METROS
FEET!!
40
FIRES UP TO
TIRE JUSQU'À 12 MÈTRES
DISPARA HASTA 12 METROS
FEET!!
DUAL TRIGGER
RAPID FIRE ACTION
DOUBLE GÂCHETTE RAPIDE FUE ACTION
DOBLE GATILLO ACCIÓN DE FUEGO RAPIDO
DUAL TRIGGER
RAPID FIRE ACTION
DOUBLE GÂCHETTE RAPIDE FUE ACTION
DOBLE GATILLO ACCIÓN DE FUEGO RAPIDO
DUAL TRIGGER
RAPID FIRE ACTION
DOUBLE GÂCHETTE RAPIDE FUE ACTION
DOBLE GATILLO ACCIÓN DE FUEGO RAPIDO
DUAL TRIGGER
RAPID FIRE ACTION
DOUBLE GÂCHETTE RAPIDE FUE ACTION
DOBLE GATILLO ACCIÓN DE FUEGO RAPIDO

ATTENTION:
1. Before you allow your child to use Nerf Blaster Scooter, ensure that the steering
rod is fully engaged and that all the screws are tight. Also ensure that the wheels
have been correctly secured and that they show no signs of wear.
2. Warning: Protective equipment should be worn. Ensure that your child always
wears a helmet, wrist, elbow and knee pads, as well as shoes with rubber soles.
3. Ensure that your child does not ride down any steep hills. The brake is not
designed to decelerate from high downhill speeds.
4. The brake pad becomes hot when it is used. Make especially sure that your child
does not keep the brake on for a long period of time. Explain to your child that
direct skin contact may cause burns.
5. Do not allow your child to travel at speeds exceeding 6 mph. (10 Kmph)
6. Ensure that your child does not ride on roads, paths or other places with motor
vehicle trac.
7. Only one child may ride on the Nerf Blaster Scooter at any one time.
8. Never allow your child to ride the Nerf BlasterScooter at dusk or at night.
9. The Nerf BlasterScooter must not be used on wet, oily, sandy, dirty, icy, rough or
uneven surfaces.
10. Parental or adult suspension is strongly recommended.
11. Do not make any modications to the Nerf BlasterScooter.
12. Suitable for children up to approx.150cm is height for the Nerf Blaster and
approx. (consider removing this line).
13. Important: Undoing the axle screws several times will reduce the eect of the
screw securing products. This means that the screws may come loose by themselves.
You should therefore always use a conventional screw securing product.
14. Some metal parts may corrode after a certain time, especially when used near
the sea or left outdoors too often.
15. Warning! The toy needs to be used with caution, since skill is required to avoid
falls or collisions causing injury to the useror third parties.
16. User age and maximum loading weight. 175lbs. (80kg) max and 6+ years
1.

PARTS LIST
Adult assembly required.
Warning! Not to be used by children under 36 months due to small parts while
unassembled. Choking Hazard.
Tips: Please verify that all pieces are included prior to beginning assembly.
2.

X6 C
BATTERIES
NOT INCLUDED
ASSEMBLY
Step 1: Step 2:
Step 3: Step 4:
Press the button and insert the stem
into the base.
Remove M6 bolt from blaster, slide the
blaster into cradle, and then tighten
blaster to cradle the M6 bolt completely.
Load 6 pcs batteries (C type, 1.5V),
close the cover and tighten 4pcs
M3 screws completely.
Insert the handlebar grips into the
bare handlebars until both locking
buttons “click” into place.
3.

DO NOT AIM AT EYES OR FACE.
TO AVOID INJURY: USE ONLY
DARTS DESIGNED FOR THIS
PRODUCT. DO NOT MODIFY
DARTS OR DART BLASTER.
BE SAFE, ALWAYS WEAR A
HELMET AND OTHER PROTEC
TIVE GEAR.
CAUTION!
BLASTER USE
HOW TO ADJUST THE HEIGHT
The handlebar can be locked into place at 2 dierent heights. Please make the
following adjustment to reach required height.
Open the Quick Release Lock, press the locking button, adjust the handlebar to a
suitable height, and then close the Quick Release Lock.
TO AVOID INJURY: Use only darts designed for this
product. Do not modify darts or dart blaster. Be sure
to read and follow all instructions carefully before
using this product. NOTE: JAM CLEARING DOOR
must be fully closed for blaster to re.
4.

FIRING
Press and hold either button trigger till
you here motors engage and dart blasts
- then release. If you keep trigger
button pressed – darts will blast in
rapid re mode very quickly.
LOADING AMMO
Load DARTS into the QUICK RELOAD
CLIPS. • Be sure DARTS are inserted in
direction indicated on CLIP. • Insert 1
DART at a time and push down. •
EACH Included CLIP can hold up to 6
DARTS. Do not insert more than
6 darts.
Insert CLIP into MAIN BLASTER UNIT (make sure arrow on CLIP points away from
TRIGGER). Press CLIP release buttons and remove CLIPS to store or reload
5.
DUAL TRIGGER
RAPID FIRE ACTION
DOUBLE GÂCHETTE RAPIDE FUE ACTION
DOBLE GATILLO ACCIÓN DE FUEGO RAPIDO
DUAL TRIGGER
RAPID FIRE ACTION
DOUBLE GÂCHETTE RAPIDE FUE ACTION
DOBLE GATILLO ACCIÓN DE FUEGO RAPIDO
DUAL TRIGGER
RAPID FIRE ACTION
DOUBLE GÂCHETTE RAPIDE FUE ACTION
DOBLE GATILLO ACCIÓN DE FUEGO RAPIDO
DUAL TRIGGER
RAPID FIRE ACTION
DOUBLE GÂCHETTE RAPIDE FUE ACTION
DOBLE GATILLO ACCIÓN DE FUEGO RAPIDO

CLEARING JAMS
Check BARREL area for a jammed
DART. Open the JAM CLEARING
DOOR and remove any jammed
DARTS. • Close JAM CLEARING DOOR.
NOTE: Blaster will not function unless
JAM CLEARING DOOR is fully closed.
NOTE: Do not store blaster ready to re. • Be sure to unload DARTS from blaster
before putting it away.
Remove batteries if storing Blaster Scooter for an extended period of time
IMPORTANT: BATTERY INFORMATION
[Caution Logo] CAUTION: 1. TO AVOID BATTERY LEAKAGE a. Always follow the
instructions carefully. Use only batteries specied and be sure to insert them
correctly by matching the + and – polarity markings. b. Do not mix old batteries and
new batteries or standard (carbon-zinc) with alkaline batteries. c. Remove
exhausted or dead batteries from the product. d. Remove batteries if product is not
to be played with for a long time. e. Do not short-circuit the supply terminals. f.
RECHARGEABLE BATTERIES: Do not mix these with any other types of batteries.
Always remove from the product before recharging. Recharge batteries under adult
supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES. 2. Should this
product cause, or be aected by, local electrical interference, move it away from
other electrical equipment. Reset (switching o and back on again or removing and
re-inserting batteries) if necessary.
STORING YOUR BLASTER
IMPORTANT: BATTERY
INFORMATION
6.

Made in China Designed in U.S.A
© 2018 Flybar, Inc. Manufacturer:
Flybar, Inc, New Jersey USA. www.fly-
bar.com 845-647-8400
HASBRO and its logo, and NERF are
trademarks of Hasbro and are used
with permission. © 2018 Hasbro. All
Rights Reserved.
MAINTENANCE AND CHECK
BEFORE RIDING
• Check that all parts are suciently tightened, and the handlebar is
securely xed.
• Check that all wheels can be spun smoothly and that the footplate is
securely fastened.
• All nuts and bolts may lose their tightness over time, please check the
tightness of all nuts and bolts every time you ride.
• The wheels may become worn out with natural wear and tear over
time. Please check the condition of the wheels regularly and replace
them when necessary. Please contact Manufacturer – Flybar, Inc. for
replacements.
• DO NOT use a wet cloth, alcohol, industrial cleaners or solvents to
clean the scooter as this may result in loss of gloss, the removal of
decals or dissolve the materials in the scooter.
• Do not use attachments not included with the scooter. Do not
attempt to make any modications to the scooter by yourself.
7.