NEUTRIK Dual Plug NP3TT-2 User manual

First slide the housing onto the cable and
insert the sealing cap into the other hole.A
Prepare the cable by stripping 25 mm of the
jacket.
Reduce the shielding strands to a length
of 7 mm and bend them over the jacket.
Shorten the wires and strip the insulation as
indicated in figure 2.
Slide the prepared end of the cable into
the open end of the plug, so that 9 mm of
unstripped cable rests inside the plug.
Next crimp the end of the plug with a
standard 6.35 mm hexagonal crimping tool
(RG 58).
Crimp only in the area designated in
figure 4!_
figure 2
figure 3
figure 4
figure 1
NEUTRIK
NP3TT-2
A
7
15
15
20
20
25
25
10
10
3
T1
R1
T2
R2
Dual Plug NP3TT-2
0.173” (4.4 mm) BANTAM-TYPE MINIATURE PLUGS
Assembly Instructions
NEUTRIK
NP3TT-2

figure 6
figure 5
B
C
NEUTRIK
NP3TT-2
Heat the tip terminal labelled with a
soldering bit, then position the shorter
wire (T1) on the heated terminal and allow
solder to melt affixing the wire to the
terminal. Repeat the process with the ring
terminal labelled in figure 5 with the
longer wire (R1).
Connect the second plug correspondingly.
B
C
Finish the installation sliding the housing
over both plugs. Turn the screw into
the housing and fasten it while fixing both
connectors to the housing.
D
Data subject to change without prior notice. 2001 NEUTRIK . ALL RIGHTS RESERVED.®
R
N E U T I K R
R
CONNECTING THE WORLD
NEUTRIK AG NEUTRIK NEUTRIK NEUTRIK NEUTRIK NEUTRIKZürich AG (UK) Ltd. USA INC. Tokyo Ltd. Vertriebs GmbH
Liechtenstein Great BritainSwitzerland USA Japan Germany / Netherlands
Tel.: [phone] Tel.: [phone]
Fax: [phone] Fax: [phone]
Tel.: [phone] Tel.: [phone] Tel.: [phone] Tel.: [phone]
Fax: [phone] Fax: [phone] Fax: [phone] Fax: [phone]
www.neutrik.com
Draft. Nr.: BDA 32 /
Update:
3102M0611
23.10.2001
ASSEMBLED CONNECTOR
D
NEUTRIK
NP3TT-2